Directive 2004/107/EC of the European Parliament and of the CouncilShow full title

Directive 2004/107/EC of the European Parliament and of the Council of 15 December 2004 relating to arsenic, cadmium, mercury, nickel and polycyclic aromatic hydrocarbons in ambient air

Article 4U.K.Assessment of ambient air concentrations and deposition rates

1.Ambient air quality with respect to arsenic, cadmium, nickel and benzo(a)pyrene shall be assessed throughout the territory of the Member States.

2.In accordance with the criteria referred to in paragraph 7, measurement is mandatory in the following zones:

(a)zones and agglomerations in which levels are between the upper and the lower assessment threshold, and

(b)other zones and agglomerations where levels exceed the upper assessment threshold.

The measurements provided for may be supplemented by modelling techniques to provide an adequate level of information on ambient air quality.

3.A combination of measurements, including indicative measurements as referred to in Annex IV, Section I, and modelling techniques may be used to assess ambient air quality in zones and agglomerations where the levels over a representative period are between the upper and lower assessment thresholds, to be determined pursuant to Annex II, Section II.

4.In zones and agglomerations where the levels are below the lower assessment threshold, to be determined pursuant to Annex II, Section II, the sole use of modelling or objective estimation techniques for assessing levels shall be possible.

5.Where pollutants have to be measured, the measurements shall be taken at fixed sites either continuously or by random sampling. The number of measurements shall be sufficient to enable the levels to be determined.

6.The upper and lower assessment thresholds for arsenic, cadmium, nickel and benzo(a)pyrene in ambient air shall be those laid down in Section I of Annex II. The classification of each zone or agglomeration for the purposes of this Article shall be reviewed at least every five years in accordance with the procedure laid down in Section II of Annex II. Classification shall be reviewed earlier in the event of significant change in activities relevant to concentrations of arsenic, cadmium, nickel and benzo(a)pyrene, in ambient air.

7.The criteria for determining the location of sampling points for the measurement of arsenic, cadmium, nickel and benzo(a)pyrene in ambient air in order to assess compliance with the target values shall be those listed in Sections I and II of Annex III. The minimum number of sampling points for fixed measurements of concentrations of each pollutant shall be as laid down in Section IV of Annex III, and they shall be installed in each zone or agglomeration within which measurement is required if fixed measurement is the sole source of data on concentrations within it.

8.To assess the contribution of benzo(a)pyrene in ambient air, each Member State shall monitor other relevant polycyclic aromatic hydrocarbons at a limited number of measurement sites. These compounds shall include at least: benzo(a)anthracene, benzo(b)fluoranthene, benzo(j)fluoranthene, benzo(k)fluoranthene, indeno(1,2,3-cd)pyrene, and dibenz(a,h)anthracene. Monitoring sites for these polycyclic aromatic hydrocarbons shall be co-located with sampling sites for benzo(a)pyrene and shall be selected in such a way that geographical variation and long-term trends can be identified. Sections I, II and III of Annex III shall apply.

[F19. Irrespective of concentration levels, one background sampling point shall be installed every 100 000 km 2 for the indicative measurement, in ambient air, of arsenic, cadmium, nickel, total gaseous mercury, benzo(a)pyrene and the other polycyclic aromatic hydrocarbons referred to in paragraph 8, and of the total deposition of arsenic, cadmium, mercury, nickel, benzo(a)pyrene and the other polycyclic aromatic hydrocarbons referred to in paragraph 8. Each Member State shall set up at least one measuring station. However, Member States may, by agreement, and in accordance with guidelines to be drawn up under the regulatory procedure referred to in Article 6(2), set up one or several common measuring stations, covering neighbouring zones in adjoining Member States, to achieve the necessary spatial resolution. Measurement of particulate and gaseous divalent mercury is also recommended. Where appropriate, monitoring shall be coordinated with the European Monitoring and Evaluation of Pollutants (EMEP) monitoring strategy and measurement programme. The sampling sites for these pollutants shall be selected in such a way that geographical variation and long-term trends can be identified. Sections I, II and III of Annex III shall apply.]

10.The use of bio indicators may be considered where regional patterns of the impact on ecosystems are to be assessed.

11.For zones and agglomerations within which information from fixed measurement stations is supplemented by information from other sources, such as emission inventories, indicative measurement methods and air quality modelling, the number of fixed measuring stations to be installed and the spatial resolution of other techniques shall be sufficient for the concentrations of air pollutants to be established in accordance with Section I of Annex III and Section I of Annex IV.

12.Data quality objectives are laid down in Section I of Annex IV. Where air quality models are used for assessment, Section II of Annex IV shall apply.

13.The reference methods for the sampling and analysis of arsenic, cadmium, mercury, nickel and polycyclic aromatic hydrocarbons in ambient air shall be as laid down in Sections I, II and III of Annex V. Section IV of Annex V sets out reference techniques for measuring the total deposition of arsenic, cadmium, mercury, nickel and the polycyclic aromatic hydrocarbons and Section V of Annex V refers to reference air quality modelling techniques when such techniques are available.

14.The date by which Member States shall inform the Commission of the methods used for the preliminary assessment of air quality under Article 11(1)(d) of Directive 96/62/EC shall be the date referred to in Article 10 of this Directive.

[F115. Any amendments necessary to adapt the provisions of this Article and of Section II of Annex II and of Annexes III, IV and V to scientific and technical progress shall be adopted by the Commission. Those measures, designed to amend non-essential elements of this Directive, shall be adopted in accordance with the regulatory procedure with scrutiny referred to in Article 6(3). They may not result in any direct or indirect changes to target values.]