Search Legislation

Regulation (EU) No 168/2013 of the European Parliament and of the CouncilShow full title

Regulation (EU) No 168/2013 of the European Parliament and of the Council of 15 January 2013 on the approval and market surveillance of two- or three-wheel vehicles and quadricycles (Text with EEA relevance)

 Help about what version

What Version

 Help about advanced features

Advanced Features

 Help about opening options

Opening OptionsExpand opening options

 Help about UK-EU Regulation

Legislation originating from the EU

When the UK left the EU, legislation.gov.uk published EU legislation that had been published by the EU up to IP completion day (31 December 2020 11.00 p.m.). On legislation.gov.uk, these items of legislation are kept up-to-date with any amendments made by the UK since then.

Changes over time for: Article 39

 Help about opening options

Status:

Point in time view as at 31/01/2020.

Changes to legislation:

Regulation (EU) No 168/2013 of the European Parliament and of the Council, Article 39 is up to date with all changes known to be in force on or before 09 November 2024. There are changes that may be brought into force at a future date. Changes that have been made appear in the content and are referenced with annotations. Help about Changes to Legislation

Article 39U.K.Statutory plate with the appropriate marking of vehicles and type-approval mark of components or separate technical units

1.The manufacturer of a vehicle shall affix to each vehicle manufactured in conformity with the approved type a statutory plate with the appropriate marking required by the relevant implementing act adopted pursuant to paragraph 3.

2.The manufacturer of a component or separate technical unit, whether or not it is part of a system, shall affix to each component or separate technical unit manufactured in conformity with the approved type the type-approval mark required by the relevant implementing act adopted pursuant to this Regulation or the relevant UNECE regulation.

Where no such type-approval mark is required, the manufacturer shall affix at least the trade name or trade mark of the manufacturer, the type number or an identification number.

3.The statutory plate and EU type-approval mark shall be in accordance with the model set out by the Commission by means of implementing acts. Those implementing acts shall be adopted in accordance with the examination procedure referred to in Article 73(2). The first such implementing acts shall be adopted by 31 December 2014.

Back to top

Options/Help