Commission Regulation (EC) No 376/2008 (repealed)Dangos y teitl llawn

Article 32 U.K.

1. The proof required under Article 31 shall be furnished as follows:

(a) in the cases referred to in Article 31(a), by production of copy No 1 of the licence or certificate and, where applicable, of copy No 1 of the extract or extracts from the licence or certificate, endorsed as provided for in Article 23 or Article 24;

(b) in the cases referred to in Article 31(b), and subject to paragraph 2 of this Article, by production of copy No 1 of the licence or certificate and, where applicable, of copy No 1 of the extract or extracts of the licence or certificate, endorsed as provided for in Article 23 or Article 24.

2. In addition, in the case of export from the Community or of supplies to a destination within the meaning of Article 36 of Regulation (EC) No 800/1999 or the placing of products under the arrangements provided for in Article 40 of that Regulation, additional proof shall be required.

Such additional proof shall be furnished as follows:

(a) where the following operations take place within the Member State in question, such additional proof shall be left to the choice of the Member State in which:

(i)

the licence or certificate is issued;

(ii)

the declaration referred to in Article 23(1)(b) of this Regulation is accepted; and

(iii)

the product:

• left the Community's customs territory. For the purposes of this Regulation deliveries of any products intended solely for consumption on board drilling or extraction platforms, including workpoints providing support services for such operations, situated within the area of the European continental shelf, or within the area of the continental shelf of the non-European part of the Community, but beyond a three-mile zone starting from the baseline used to determine the width of a Member State's territorial sea, shall be deemed to have left the Community's customs territory,

• is delivered to one of the destinations listed in Article 36 of Regulation (EC) No 800/1999, or

• is placed in a victualling warehouse under Article 40 of Regulation (EC) No 800/1999;

(b) in all other cases, the additional proof shall be furnished by:

(i)

production of the control copy T5 or copies referred to in Article 912a of Regulation (EEC) No 2454/93 or a certified copy or photocopy of such control copy T5 or copies; or

(ii)

an attestation given by the agency responsible for paying the refund that the conditions of Article 31(b) of this Regulation have been fulfilled; or

(iii)

equivalent proof as provided for in paragraph 4 of this Article.

Where the sole purpose of the T5 control copy is the release of the security, the T5 control copy shall contain in Section 106 one of the entries listed in Annex III, Part C, to this Regulation.

However, if an extract of a licence or certificate, a replacement licence or certificate or a replacement extract is used, that entry shall also state the number of the original licence or certificate and the name and address of the issuing body.

The documents referred to in points (b)(i) and (ii) shall be sent to the issuing body through official channels.

3. Where, after acceptance of the export declaration as referred to in Article 23(1)(b), a product is placed under one of the simplified arrangements provided for in Articles 412 to 442a of Regulation (EEC) No 2454/93 or in Title X, Chapter I, of Appendix I to the Convention of 20 May 1987 on a common transit procedure for carriage to a station-of-destination or delivery to a consignee outside the Community's customs territory, the T5 control copy required under paragraph 2(b) of this Article shall be sent through official channels to the issuing body. One of the entries listed in Annex III, Part D, to this Regulation shall be entered in section ‘J’ of the T5 control copy under the heading ‘Remarks’.

In the case referred to in the first subparagraph, the office of departure may permit the contract of carriage to be amended so that carriage ends within the Community only if it is established:

(a) that, where the security has already been released, such security has been renewed; or

(b) that the necessary steps have been taken by the authorities concerned to ensure that the security is not released.

Where the security has been released without the product having been exported, Member States shall take appropriate action.

4. Where the T5 control copy referred to in paragraph 2(b) cannot be produced within three months following its issue owing to circumstances beyond the control of the party concerned, the latter may apply to the competent body for other documents to be accepted as equivalent, stating the grounds for such application and furnishing supporting documents.

The supporting documents to be submitted with the application shall be those specified in the second subparagraph of Article 49(3) of Regulation (EC) No 800/1999.