xmlns:atom="http://www.w3.org/2005/Atom" xmlns:atom="http://www.w3.org/2005/Atom"

CHAPTER IVU.K.HARMONISED TECHNICAL SPECIFICATIONS

Article 21U.K.Obligations of the TAB receiving a request for a [F1UK] Technical Assessment

1.The [F2responsible TAB] shall inform the manufacturer if the construction product is covered, fully or partially, by a harmonised technical specification as follows:

(a)where the product is fully covered by a [F3designated] standard, the TAB shall inform the manufacturer that, in accordance with Article 19(1), a [F4UK] Technical Assessment cannot be issued;

(b)where the product is fully covered by a [F5UK] Assessment Document, the TAB shall inform the manufacturer that such a document will be used as the basis for the [F5UK] Technical Assessment to be issued;

(c)where the product is not covered, or not fully covered, by any harmonised technical specification, the TAB shall apply the procedures set out in Annex II or those established in accordance with Article 19(3).

[F61A.A TAB may use a pre-exit European Assessment Document as a UK Assessment Document provided it has obtained any necessary consent to do so from the organisation of TABs established under the EU Construction Products Regulation.]

[F71B.Paragraph (1)(a) and (1)(c) apply only to TABs that are established in the United Kingdom.]

2.In the cases referred to in points (b) and (c) of paragraph 1, the [F8responsible] TAB shall inform F9... the [F10Secretary of State] of the content of the request and of the reference to a relevant [F10Secretary of State] decision for assessment and verification of constancy of performance, which the TAB intends to apply for that product, or of the lack of such a [F10Secretary of State] decision.

3.If the [F11Secretary of State] considers that an appropriate decision for assessment and verification of constancy of performance does not exist for the construction product, Article 28 shall apply.

Textual Amendments