Please note that the date you requested in the address for this web page is not an actual date upon which a change occurred to this item of legislation. You are being shown the legislation from , which is the first date before then upon which a change was made.
For the product(s) and intended use(s) listed below, CEN/CENELEC are requested to specify the following system(s) of attestation of conformity in the relevant harmonized standard(s):
System 1 +: | |||
See Annex III Section 2 (i) of Directive 89/106/EEC, with audit-testing of samples taken at the factory | |||
System 2: | |||
See Annex III Section 2 (ii) of Directive 89/106/EEC, first possibility, including certification of the factory production control by an approved body on the basis of initial inspection of factory and of factory production control (without continous surveillance, assessment and approval of factory production control) | |||
System 2 +: | |||
See Annex III Section 2 (ii) of Directive 89/106/EEC, first possibility, including certification of the factory production control by an approved body on the basis of initial inspection of factory and of factory production control as well as of continuous surveillance, assessment and approval of factory production control | |||
Product(s) | Intended use(s) | Level(s) or class(es) | Attestation of conformity system(s) |
---|---|---|---|
Common cements, including:
| Preparation of concrete, mortar, grout and other mixes for construction and for the manufacture of construction products | — | 1 + |
Special cements, including:
| — | 1 + | |
Calcium aluminate cements | — | 1 + | |
Masonry cements | — | 1 + | |
[F1Building lime, including:
| — | 2 +] | |
Hydraulic road binders | Preparation of concrete, mortar, grout and other mixes for road bases stabilisation | — | 2 + |
The specification of the system should be such that it can be implemented even where performance does not need to be determined for a certain characteristic, because at least one Member State has no legal requirement at all for such characteristic [see Article 2 (1) of Directive 89/106/EEC and, where applicable, clause 1.2.3 of the Interpretative Documents]. In those cases the verification of such a characteristic must not be imposed on the manufacturer if he does not wish to declare the performance of the product in that respect.