xmlns:atom="http://www.w3.org/2005/Atom" xmlns:atom="http://www.w3.org/2005/Atom"

ANNEX 1U.K. [F1DEFINITIONS, APPLICATION FOR EC TYPE-APPROVAL, GRANTING OF EC TYPE-APPROVAL, SYMBOL OF THE CORRECTED ABSORPTION COEFFICIENT, SPECIFICATIONS AND TESTS, MODIFICATIONS OF THE TYPE, CONFORMITY OF PRODUCTION]

7.CONFORMITY OF PRODUCTIONU.K.

[F17.1. Measures to ensure the conformity of production shall be taken in accordance with the provisions laid down in Article 10 of Directive 70/156/EEC.] U.K.

F2(7.2.). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .U.K.

[F17.2. In particular, conformity of the vehicle with the approved type as regards the emission of pollutants from diesel engines shall be verified on the basis of the results listed in the Addendum to the type-approval certificate shown in Appendix 2. In addition:] U.K.

[F17.2.1.] Where a check is carried out on a vehicle taken from the series, the tests shall be carried out as follows:U.K.
[F17.2.1.1.] A vehicle which has not been run in shall be subjected to the test under free acceleration described in Annex IV. The vehicle shall be deemed to conform to the approved type if the absorption coefficient determined does not exceed by more than 0·5 m−1 the figure shown in the approval mark.U.K.
[F17.2.1.2.] If the figure determined in the test referred to in item [F17.2.1.1] above exceeds by more than 0·5 m−1 the figure shown in the approval mark, a vehicle of the type considered or its engine shall be subjected to the test at steady speeds over the full-load curve, as described in Annex III. The emission levels shall not exceed the limits prescribed in [F3Annex V].U.K.