Commission Directive 2005/10/EC (repealed)Show full title

ANNEX I U.K. METHODS OF SAMPLING FOR OFFICIAL CONTROL OF THE LEVELS OF BENZO(A)PYRENE IN FOODSTUFFS

1. Purpose and Scope U.K.

Samples intended for official checking of the levels of benzo(a)pyrene in foodstuffs shall be taken according to the methods described below. Aggregate samples thus obtained shall be considered as representative of the lots. Compliance with maximum levels laid down in Regulation (EC) No 466/2001 shall be established on the basis of the levels determined in the laboratory samples.

2. Definitions U.K.

‘Lot’: an identifiable quantity of a food commodity delivered at one time and having been determined by the official to have common characteristics, such as origin, variety, type of packing, packer, consignor or markings.

‘Sublot’: designated part of a lot in order to apply the sampling method on that designated part; each sublot must be physically separate and identifiable.

‘Incremental sample’: a quantity of material taken from a single place in the lot or sublot.

‘Aggregate sample’: the combined total of all the incremental samples taken from the lot or sublot.

‘Laboratory sample’: sample intended for the laboratory.

3. General provisions U.K.

3.1. Personnel U.K.

Sampling shall be performed by an authorised person as specified by the Member States.

3.2. Material to be sampled U.K.

Each lot which is to be examined must be sampled separately.

3.3. Precautions to be taken U.K.

In the course of sampling and preparation of the samples precautions must be taken to avoid any changes, which would affect the benzo(a)pyrene content, adversely affect the analytical determination or make the aggregate samples unrepresentative.

3.4. Incremental samples U.K.

As far as possible incremental samples should be taken at various places distributed throughout the lot or sublot. Departure from this procedure must be recorded in the record.

3.5. Preparation of the aggregate sample U.K.

The aggregate sample is made up by uniting all incremental samples. This aggregate sample is homogenised in the laboratory unless this is incompatible with implementation of point 3.6.

3.6. Replicate laboratory samples U.K.

Replicate laboratory samples for enforcement, trade (defence) and referee purposes shall be taken from the homogenised aggregate sample unless this conflicts with Member States’ rules on sampling.

3.7. Packaging and transmission of samples U.K.

Each sample shall be placed in a clean, inert container offering adequate protection from contamination and against damage in transit. All necessary precautions shall be taken to avoid any change in composition of the sample, which might arise during transportation or storage.

3.8. Sealing and labelling of samples U.K.

Each sample taken for official use shall be sealed at the place of sampling and identified following the Member State’s rules.

A record must be kept of each sampling, permitting each lot to be identified unambiguously and giving the date and place of sampling together with any additional information likely to be of assistance to the analyst.

4. Sampling plans U.K.

The sampling method applied shall ensure that the aggregate sample is representative for the lot that is to be controlled.

4.1. Number of incremental samples U.K.

In the case of oils, for which a homogeneous distribution of benzo(a)pyrene can be assumed within a given lot, it is sufficient to take three incremental samples per lot to form the aggregate sample. Reference to the lot number shall be given. For olive oil and olive pomace oil further information on sampling is given in Commission Regulation (EC) No 1989/2003(1).

For other products, the minimum number of incremental samples to be taken from the lot shall be as given in Table 1. The incremental samples shall be of similar weight, no less than 100g each, resulting in an aggregate sample of no less than 300g (see point 3.5).

TABLE 1

Minimum number of incremental samples to be taken from the lot

Weight of lot (in kg)	Minimum number of incremental samples to be taken
< 50	3
50 to 500	5
> 500	10

If the lot consists of individual packages, then the number of packages which shall be taken to form the aggregate sample is given in Table 2.

TABLE 2

Number of packages (incremental samples) which shall be taken to form the aggregate sample if the lot consists of individual packages

Number of packages or units in the lot or sublot	Number of packages or units to be taken
1 to 25	1 package or unit
26 to 100	About 5 %, at least 2 packages or units
> 100	About 5 %, at maximum 10 packages or units

4.2. Sampling at retail stage U.K.

Sampling of foodstuffs at the retail stage should be done where possible in accordance with the above sampling provisions. Where this is not possible, other effective sampling procedures at retail stage can be used provided that they ensure sufficient representativeness for the sampled lot.

5. Compliance of the lot or sublot with the specification U.K.

The control laboratory shall analyse the laboratory sample for enforcement in duplicate analyses in cases where the obtained result of the first analysis is less than 20 % below or above the maximum level, and in these cases shall calculate the mean of the results.

The lot is accepted if the result of the first analysis or, where duplicate analysis is necessary, if the mean does not exceed the respective maximum level (as laid down in Regulation (EC) No 466/2001) taking into account the measurement uncertainty and correction for recovery.

The lot is non-compliant with the maximum level (as laid down in Regulation (EC) 466/2001) if the result of the first analysis or, where duplicate analysis is necessary, if the mean exceeds the maximum level beyond reasonable doubt taking into account the measurement uncertainty and correction for recovery.

(1)

OJ L 295, 13.11.2003, p. 57.