Directive 2006/32/EC of the European Parliament and of the Council (repealed)Show full title

2. Data and methods that may be used (measurability) U.K.

Several methods for collecting data to measure and/or estimate energy savings exist. At the time of the evaluation of an energy service or energy efficiency improvement measure, it will often be impossible to rely only on measurements. A distinction is therefore made between methods measuring energy savings and methods estimating energy savings, where the latter is the more common practice.

2.1. Data and methods based on measurements U.K.

Bills from distribution companies or retailers U.K.

Metered energy bills may form the basis for measurement for a representative period before the introduction of the energy efficiency improvement measure. These may then be compared to metered bills for the period after the introduction and use of the measure, also for a representative period of time. The findings should be compared to a control group (non-participation group) if possible or, alternatively, normalised as described in point 1.2.

Energy sales data U.K.

The consumption of different types of energy (e.g. electricity, gas, heating oil) may be measured by comparing the sales data from the retailer or distributor obtained before the introduction of the energy efficiency improvement measures with the sales data from the time after the measure. A control group may be used or the data normalised.

Equipment and appliance sales data U.K.

Performance of equipment and appliances may be calculated on the basis of information obtained directly from the manufacturer. Data on equipment and appliance sales can generally be obtained from the retailers. Special surveys and measurements may also be carried out. The accessible data can be checked against sales figures to determine the size of energy savings. When using this method, adjustment should be made for changes in the use of the equipment or appliance.

End-use load data U.K.

Energy use of a building or facility can be fully monitored to record energy demand before and after the introduction of an energy efficiency improvement measure. Important relevant factors (e.g. production process, special equipment, heating installations) may be metered more closely.

2.2. Data and methods based on estimates U.K.

Simple engineering estimated data: Non-inspection U.K.

Simple engineering estimated data calculation without on-site inspection is the most common method for obtaining data for measuring deemed energy savings. Data may be estimated using engineering principles, without using on-site data, but with assumptions based on equipment specifications, performance characteristics, operation profiles of measures installed and statistics, etc.

Enhanced engineering estimated data: Inspection U.K.

Energy data may be calculated on the basis of information obtained by an external expert during an audit of, or other type of visit to, one or several targeted sites. On this basis, more sophisticated algorithms/simulation models could be developed and be applied to a larger population of sites (e.g. buildings, facilities, vehicles). This type of measurement can often be used to complement and calibrate simple engineering estimated data.