Search Legislation

Commission Directive 2008/61/ECShow full title

Commission Directive 2008/61/EC of 17 June 2008 establishing the conditions under which certain harmful organisms, plants, plant products and other objects listed in Annexes I to V to Council Directive 2000/29/EC may be introduced into or moved within the Community or certain protected zones thereof, for trial or scientific purposes and for work on varietal selections (Codified version)

 Help about what version

What Version

 Help about advanced features

Advanced Features

 Help about UK-EU Regulation

Legislation originating from the EU

When the UK left the EU, legislation.gov.uk published EU legislation that had been published by the EU up to IP completion day (31 December 2020 11.00 p.m.). On legislation.gov.uk, these items of legislation are kept up-to-date with any amendments made by the UK since then.

Close

This item of legislation originated from the EU

Legislation.gov.uk publishes the UK version. EUR-Lex publishes the EU version. The EU Exit Web Archive holds a snapshot of EUR-Lex’s version from IP completion day (31 December 2020 11.00 p.m.).

Status:

EU Directives are published on this site to aid cross referencing from UK legislation. Since IP completion day (31 December 2020 11.00 p.m.) no amendments have been applied to this version.

Section IV:U.K.Plants of stolon- or tuber-forming species of Solanum L. or their hybrids, intended for planting

1.The plant material, as appropriate, shall be subjected to the therapy procedures as laid down in FAO/IPGRI Technical Guidelines.U.K.

2.Each unit of the plant material, following the therapy procedures carried out pursuant to point 1, shall be subjected to indexing procedures. All plant material, including indexing plants, shall be held at the approved facilities under the quarantine containment conditions laid down in Annex I. Plant material intended for approval for official release shall be held under conditions conducive to a normal cycle of vegetative growth and be subjected to visual inspection for signs and symptoms of harmful organisms including all relevant harmful organisms listed in Directive 2000/29/EC and potato yellow vein disease, on arrival and subsequently, at regular intervals until senescence, during the period of the indexing procedures.U.K.

3.The indexing procedures referred to in point 2 shall follow the technical provisions set out in point 5, in order to detect at least the following harmful organisms:U.K.

  • Bacteria

    (a)

    Clavibacter michiganensis (Smith) Davis et al. ssp. sepedonicus (Spieckermann et Kotthoff) Davis et al.;

    (b)

    Ralstonia solanacearum (Smith) Yabuuchi et al.

  • Viruses and virus-like organisms

    (a)

    Andean potato latent virus,

    (b)

    Potato black ringspot virus,

    (c)

    Potato spindle tuber viroid,

    (d)

    Potato yellowing alfamovirus,

    (e)

    Potato virus T,

    (f)

    Andean potato mottle virus,

    (g)

    Common potato viruses A, M, S, V, X and Y (including Yo, Yn and Yc) and potato leaf roll virus.

However, in the case of true seed of potato, the indexing procedures shall be carried out in order to detect at least the viruses and virus-like organisms listed above at (a) to (e).

4.The plant material subjected to the visual inspections referred to in point 2 and on which signs and symptoms of harmful organisms have been observed shall be subjected to an investigation including testing where necessary, to determine, as far as possible, the identity of the harmful organisms causing the signs and symptoms.U.K.

5.The technical provisions referred to in point 3 shall be as follows:U.K.

  • Bacteria

    1.

    For tubers, test the heel end of each tuber. The standard sample size shall be 200 tubers. However, the procedure can be applied for samples with less than 200 tubers.

    2.

    For young plants and cuttings, including micro-plants, test the lower sections of the stem and, where appropriate, the roots, for each unit of the plant material.

    3.

    For testing of progeny tubers, or of stem bases for non-tuber forming species, one normal cycle of vegetative growth after the testing referred to in points 1 and 2, is recommended.

    4.

    For the material referred to in point 1, the testing method for Clavibacter michiganensis (Smith) Davis et al. ssp. sepedonicus (Spieckermann et Kotthoff) Davis et al. shall be the Community method set out in Annex I to Council Directive 93/85/EEC(1). For the material referred to in point 2, this testing method could be applied.

    5.

    For the material referred to in point 1, the testing method for Ralstonia solanacearum (Smith) Yabuuchi et al. shall be the test scheme set out in Annex II to Council Directive 98/57/EC(2). For the material referred to in point 2, this testing method could be applied.

  • Viruses and virus-like organisms, other than potato spindle tuber viroid

    1.

    The minimum testing for vegetative material (tubers, young plants and cuttings, including micro-plants) shall include a serological test done at or near flowering for each of the specified list of harmful organisms other than potato spindle tuber viroid, and followed by a biological test of material testing negative in the serological test. For Potato leaf roll virus, two serological tests shall be done.

    2.

    The minimum testing for true seed shall be a serological test or a biological test if no serological test is available. Retesting of a proportion of negative samples and testing of borderline results by another method is highly recommended.

    3.

    The serological and biological testing referred to in points 1 and 2 shall be done on glasshouse grown plants, sampled from at least two positions on every stem, including a young fully expanded leaflet at the top of each stem and an older leaflet from a midway position; each stem shall be sampled because of possible non-systemic infection. In the case of the serological testing, no bulking of leaflets from separate plants shall be done, unless the bulking rate has been validated for the method of use; leaflets from each stem may however be bulked to make up the sample from each plant. In the case of the biological testing, the maximum bulking is up to five plants with inoculation of a minimum of duplicate indicator plants.

    4.

    The appropriate indicator plants to be used for the biological testing referred to in points 1 and 2 shall be those listed by the European and Mediterranean Plant Protection Organization (EPPO), or other officially approved indicator plants, which have been shown to detect the viruses.

    5.

    Only material which has been directly tested shall be released from quarantine. Where eye indexing has been done, only the progeny of the tested eye may be released. The tuber should not be released because of possible problems with non-systemic infection.

  • Potato spindle tuber viroid

    1.

    For all material, glasshouse grown plants shall be tested, as soon as they are well established but prior to flowering and pollen production. Testing on tuber sprouts/in vitro plants/small seedlings shall only be regarded as a preliminary test.

    2.

    Samples shall be taken from a fully expanded leaflet at the top of each stem of the plant.

    3.

    All material for testing shall be grown at temperatures not less than 18 °C (preferably at temperatures higher than 20 °C) and with at least a 16-hour photo-period.

    4.

    Testing shall be by radioactive or non-radioactive labelled cDNA or RNA-probes, return-PAGE (with silver staining) or RT-PCR.

    5.

    The maximum bulking rate for probes and return-PAGE is 5. Use of this or higher bulking rates must be validated.

(1)

OJ L 259, 18.10.1993, p. 1. Directive as amended by Commission Directive 2006/56/EC (OJ L 182, 4.7.2006, p. 1).

(2)

OJ L 235, 21.8.1998, p. 1. Directive as amended by Commission Directive 2006/63/EC (OJ L 206, 27.7.2006, p. 36).

Back to top

Options/Help

Print Options

Close

Legislation is available in different versions:

Latest Available (revised):The latest available updated version of the legislation incorporating changes made by subsequent legislation and applied by our editorial team. Changes we have not yet applied to the text, can be found in the ‘Changes to Legislation’ area.

Original (As adopted by EU): The original version of the legislation as it stood when it was first adopted in the EU. No changes have been applied to the text.

Close

See additional information alongside the content

Geographical Extent: Indicates the geographical area that this provision applies to. For further information see ‘Frequently Asked Questions’.

Show Timeline of Changes: See how this legislation has or could change over time. Turning this feature on will show extra navigation options to go to these specific points in time. Return to the latest available version by using the controls above in the What Version box.

Close

Opening Options

Different options to open legislation in order to view more content on screen at once

Close

More Resources

Access essential accompanying documents and information for this legislation item from this tab. Dependent on the legislation item being viewed this may include:

  • the original print PDF of the as adopted version that was used for the EU Official Journal
  • lists of changes made by and/or affecting this legislation item
  • all formats of all associated documents
  • correction slips
  • links to related legislation and further information resources
Close

Timeline of Changes

This timeline shows the different versions taken from EUR-Lex before exit day and during the implementation period as well as any subsequent versions created after the implementation period as a result of changes made by UK legislation.

The dates for the EU versions are taken from the document dates on EUR-Lex and may not always coincide with when the changes came into force for the document.

For any versions created after the implementation period as a result of changes made by UK legislation the date will coincide with the earliest date on which the change (e.g an insertion, a repeal or a substitution) that was applied came into force. For further information see our guide to revised legislation on Understanding Legislation.

Close

More Resources

Use this menu to access essential accompanying documents and information for this legislation item. Dependent on the legislation item being viewed this may include:

  • the original print PDF of the as adopted version that was used for the print copy
  • correction slips

Click 'View More' or select 'More Resources' tab for additional information including:

  • lists of changes made by and/or affecting this legislation item
  • confers power and blanket amendment details
  • all formats of all associated documents
  • links to related legislation and further information resources