Directive 2009/45/EC of the European Parliament and of the CouncilShow full title

10 Double bottoms (R 12)

NEW CLASS B, C AND D AND EXISTING CLASS B SHIPS, AND NEW SHIPS CONSTRUCTED ON OR AFTER 1 JANUARY 2003 WITH A LENGTH OF 24 METRES AND ABOVE.

.1 In new class B, C and D and existing class B ships, and new ships constructed on or after 1 January 2003 with a length of 24 metres and above, a double bottom shall be fitted extending from the forepeak bulkhead to the afterpeak bulkhead as far as this is practicable and compatible with the design and proper working of the ship.

.1

In ships of 50 metres and upwards but less than 61 metres in length, a double bottom shall be fitted at least from the machinery space to the forepeak bulkhead, or as near thereto as practicable.

.2

In ships of 61 metres and upwards but less than 76 metres in length, a double bottom shall be fitted at least outside the machinery space and shall extend to the fore and after peak bulkheads or as near thereto as practicable.

.3

In ships of 76 metres in length and upwards, a double bottom shall be fitted amidships and shall extend to the fore and after peak bulkhead or as near as practicable.

.2 Where a double bottom is required to be fitted its depth shall comply with the standards of a recognised organisation and the inner bottom shall be continued out to the ship's sides in such a manner as to protect the bottom to the turn of the bilge. Such protection will be deemed satisfactory if the line of intersection of the outer edge of the margin plate with the bilge plating is not lower at any part than a horizontal plane passing through the point of intersection with the frame line amidships of a transverse diagonal line inclined at 25 ° to the base line and cutting it at a point one half of the ship's moulded breadth from the middle line.

.3 Small wells constructed in the double bottom in connection with drainage arrangements of holds, etc., shall not extend downwards more than necessary. The depth of the well shall in no case be more than the depth less 460 mm of the double bottom at the centreline, nor shall the well extend below the horizontal plane referred to in paragraph .2. A well extending to the outer bottom is, however, permitted at the after end of the shaft tunnel. Other wells (e.g. for lubricating oil under main engines) may be permitted by the Administration of the flag State if satisfied that the arrangements give protection equivalent to that afforded by a double bottom complying with this regulation.

.4 A double bottom need not be fitted in way of watertight compartments of moderate size used exclusively for the carriage of liquids, provided the safety of the ship, in the event of bottom or side damage, is not, in the opinion of the Administration of the flag State, thereby impaired.

.5 Notwithstanding paragraph .1 of this Regulation 10, the Administration of the flag State may permit a double bottom to be dispensed with in any part of the ship which is subdivided by a factor not exceeding 0,5, if satisfied that the fitting of a double bottom in that part would not be compatible with the design and proper working of the ship.