Please note that the date you requested in the address for this web page is not an actual date upon which a change occurred to this item of legislation. You are being shown the legislation from , which is the first date before then upon which a change was made.
Introductory Text
CHAPTER I SUBJECT MATTER, SCOPE AND DEFINITIONS
Article 1.Subject matter
Article 2.Scope
Article 3.Definitions
CHAPTER II OBLIGATIONS OF MANUFACTURERS
Article 4.General obligations
Article 5.General requirements and tests
Article 6.Specific requirements relating to certain vehicles of categories N and O
Article 7.Specific requirements relating to vehicles of categories M2 and M3
Article 8.Classification of tyres
Article 9.Specific provisions relating to vehicle tyres, installation of tyres and tyre pressure monitoring systems
Article 10.Advanced vehicle systems
Article 11.Gear shift indicators
Article 12.Electronic stability control systems
CHAPTER III OBLIGATIONS OF THE MEMBER STATES
Article 13.Type-approval of vehicles, components and separate technical units
CHAPTER IV IMPLEMENTATION
Article 14.Implementing measures
Article 15.Committee procedure
CHAPTER V FINAL PROVISIONS
Article 16.Penalties for non-compliance
Article 17.Reporting
Article 18.Amendments to Directive 2007/46/EC
Article 19.Repeal
Article 20.Entry into force
Signature
ANNEX I
Scope of application of the requirements referred to in Article 5(1) and (2)
Vehicles of this category shall be fitted with an adequate...
ANNEX II
Requirements for tyres with regard to wet grip, rolling resistance and rolling noise
PART A — WET GRIP REQUIREMENTS
PART B — ROLLING RESISTANCE REQUIREMENTS
PART C — ROLLING NOISE REQUIREMENTS
1. The noise levels determined in accordance with the procedure specified...
1.1. Class C1 tyres, with reference to the nominal section width...
1.2. Class C2 and C3 tyres, with reference to the category...
ANNEX III
Amendments to Directive 2007/46/EC
Directive 2007/46/EC is hereby amended as follows:
Part I of Annex IV shall be amended as follows:...
ANNEX IV
List of UNECE Regulations which apply on a compulsory basis
Regulation Number Subject Series of amendments published in the OJ...
Notes to the table:
( a ) UNECE Regulation Nos 1, 8 and 20 are not applicable...
( b ) The fitting of an electronic stability control system is required...
( c ) The fitting of an electronic stability control system is required...
( d ) A safety-belt reminder is not required for a driver position...
( e ) Compliance with Part II of UNECE Regulation No 34 is...
( f ) Where it is declared by the vehicle manufacturer that a...
( g ) Only Speed Limitation Devices (SLD) and the mandatory installation of...
( h ) A Universal International Whole Vehicle Type Approval issued under UN...
( i ) Tyre pressure monitoring system for M1 vehicles applies on a...
Appendix
Validity and extension of approvals granted under the Directives repealed...
Notes to the table:
( a ) Not applicable for vehicle types equipped with electric propulsion.
( b ) Not applicable for vehicle types in case of design changes...
( c ) Only applicable for special purpose completed vehicles of category M...
( d ) Not applicable for radio receiving or transmitting aerials considered as...
( e ) Only applicable for Class C1 tyres manufactured before, on or...
( f ) Not covering Part II of UNECE Regulation No 34.
( g ) See Article 4 of Regulation (EU) No 130/2012 (Commission Regulation...
( h ) Not applicable for vehicle types equipped with steering equipment containing...
( i ) Notwithstanding the provisions of Article 7(1) of Regulation (EU) 2015/166...
ANNEX V
Implementation dates of the requirements for electronic stability control systems on vehicles of categories M2, M3, N2, N3, O3 and O4
Table 1 — Implementation dates for new types of vehicle...
Table 2 — Implementation dates for new vehicles Vehicle category...