Commission Delegated Regulation (EU) No 1062/2010Show full title

Commission Delegated Regulation (EU) No 1062/2010 of 28 September 2010 supplementing Directive 2010/30/EU of the European Parliament and of the Council with regard to energy labelling of televisions (Text with EEA relevance)

  1. Introductory Text

  2. Article 1.Subject matter

  3. Article 2.Definitions

  4. Article 3.Responsibilities of suppliers

  5. Article 4.Responsibilities of dealers

  6. Article 5.Measurement methods

  7. Article 6.Verification procedure for market surveillance purposes

  8. Article 7.Revision

  9. Article 8.Transitional provision

  10. Article 9.Entry into force

  11. Signature

    1. ANNEX I

      Energy efficiency class

      1. The energy efficiency class of a television shall be determined...

    2. ANNEX II

      Method for calculating the Energy Efficiency Index and the annual on-mode energy consumption

      1. 1. The Energy Efficiency Index (EEI) is calculated as EEI =...

      2. 2. The annual on-mode energy consumption E in kWh is calculated...

      3. 3. Televisions with automatic brightness control

    3. ANNEX III

      Product fiche

      1. 1. The information in the product fiche of the television shall...

      2. 2. One fiche may cover a number of television models supplied...

      3. 3. The information contained in the fiche may be given in...

    4. ANNEX IV

      Technical documentation

      1. The technical documentation referred to in Article 3(1)(c) shall include:...

      2. the name and address of the supplier; a general description...

    5. ANNEX V

      Label

      1. 1. LABEL 1

        1. (a) The following information shall be included in the label:

        2. (b) The design aspects of the label shall be in accordance...

      2. 2. LABEL 2

        1. (a) The information listed in point 1(a) shall be included in...

        2. (b) The design aspects of the label shall be in accordance...

      3. 3. LABEL 3

        1. (a) The information listed in point 1(a) shall be included in...

        2. (b) The design aspects of the label shall be in accordance...

      4. 4. LABEL 4

        1. (a) The information listed in point 1(a) shall be included in...

        2. (b) The design aspects of the label shall be in accordance...

      5. 5. The design of the label shall be the following:

    6. ANNEX VI

      Information to be provided in the cases where end-users cannot be expected to see the product displayed

      1. 1. The information referred to in Article 4(b) shall be provided...

      2. 2. Where other information contained in the product information fiche is...

      3. 3. The size and font in which all the information referred...

    7. ANNEX VII

      Measurements

      1. 1. For the purposes of compliance and verification of compliance with...

      2. 2. Measurements of on-mode power consumption referred to in point 1...

      3. 3. Measurements of standby/off-mode power consumption referred to in point 1(g)...

      4. 4. Measurements of peak luminance referred to in point 2(c) Annex...

    8. ANNEX VIII

      Verification procedure for market surveillance purposes

      1. For the purposes of checking conformity with the requirements laid...

      2. 1. Member State authorities shall test one single unit.

      3. 2. The model shall be considered to comply with the declared...

      4. 3. If the results referred to in point (2)(a) or (b)...

      5. 4. After three additional units of the same model have been...

      6. 5. If the results referred to in point (4)(a) or (b)...