xmlns:atom="http://www.w3.org/2005/Atom"
This Regulation applies to vehicles of category M1 which comply with the following requirements:
they are fitted with a manual gearbox,
they have a reference mass not exceeding 2 610 kg or type-approval is extended to them in accordance with Article 2(2) of Regulation (EC) No 715/2007.
This Regulation does not apply to ‘vehicles designed to fulfil specific social needs’ as defined in Article 3(2)(c) of Regulation (EC) No 715/2007.
For the purposes of this Regulation, the following definitions shall apply in addition to the definitions set out in Regulation (EC) No 661/2009:
‘vehicle type with regard to the GSI’ means a group of vehicles, which do not differ with respect to functional characteristics of the GSI and the logic used by the GSI to determine when to indicate a gearshift point. Examples of different logics include, but are not limited to:
upshifts indicated at specified engine speeds;
upshifts indicated when specific fuel consumption engine maps show that a specified minimum fuel consumption improvement will be delivered in the higher gear;
upshifts indicated when torque demand can be met in the higher gear;
‘functional characteristics of the GSI’ means the set of input parameters, such as engine speed, power demand, torque and their variation in time, determining the GSI indication and the functional dependence of the GSI indications on these parameters;
‘operational mode of the vehicle’ means a state of the vehicle, in which shifts between at least two forward gears may occur;
‘manual mode’ means an operational mode of the vehicle, where the shift between all or some of the gears is always an immediate consequence of an action of the driver;
‘tailpipe emissions’ means tailpipe emissions as defined in Article 3(6) of Regulation (EC) No 715/2007.
For the purpose of assessing whether a gearbox meets the definition according to Article 3(16) of Regulation (EC) No 661/2009, a gearbox having at least one manual mode according to Article 2(4) of this Regulation shall be considered as a ‘manual gearbox’. For this assessment, automatic changes between gears, which are performed not to optimise the operation of the vehicle but only under extreme conditions for reasons such as protecting or avoiding the stalling of the engine, are not considered.
1.Manufacturers shall ensure that vehicles placed on the market, which are covered by Article 11 of Regulation (EC) No 661/2009, are equipped with GSI in accordance with the requirements of Annex I to this Regulation.
2.To obtain an EC type-approval for the vehicles covered by Article 11 of Regulation (EC) No 661/2009, the manufacturer shall fulfil the following obligations:
(a)draw up and submit to the type-approval authority an information document in accordance with the model set out in Part 1 of Annex II to this Regulation;
(b)submit to the type-approval authority a declaration laying down that, according to the manufacturer’s assessment, the vehicle complies with the requirements set out in this Regulation;
(c)present to the type-approval authority a certificate established in accordance with the model set out in Part 2 of Annex II to this Regulation;
(d)either
submit to the type-approval authority the GSI gear shift points determined analytically as provided for in the last paragraph of point 4.1 to Annex I; or
submit to the technical service responsible for conducting the type-approval tests a vehicle which is representative of the vehicle type to be approved to enable the test described in point 4 of Annex I to be carried out.
3.Based on the elements provided by the manufacturer under points (a), (b) and (c) of paragraph 2 and the results of the type-approval test referred to in point (d) of paragraph 2, the type-approval authority shall assess compliance with the requirements of Annex I.
It shall issue an EC type-approval certificate according to the model set out in Part 3 of Annex II to this Regulation for the vehicles covered by Article 11 of Regulation (EC) No 661/2009 only if such compliance is established.
For the purpose of monitoring the effects of this Regulation and evaluating the need for further developments, manufacturers and type-approval authorities shall make available to the Commission, upon request, the information set out in Annex II. This information shall be treated in a confidential manner by the Commission and its delegates.
Annexes I, III, IV, VI and XI to Directive 2007/46/EC are amended in accordance with Annex III to this Regulation.
This Regulation shall enter into force on the 20th day following its publication in the Official Journal of the European Union.
This Regulation shall be binding in its entirety and directly applicable in all Member States.
Done at Brussels, 24 January 2012.
For the Commission
The President
José Manuel Barroso