Article 3Fitting and demonstration requirements related to vehicle construction
1.In order to comply with the vehicle construction requirements as laid down in Article 18 of, and Annex II to, Regulation (EU) No 168/2013, manufacturers shall equip L-category vehicles with systems, components and separate technical units affecting functional safety and environmental protection that are designed, constructed and assembled so as to enable the vehicle in normal use and maintained according to the prescriptions of the manufacturer to comply with the detailed technical requirements and testing procedures.
2.In accordance with Articles 6 to 20 manufacturers shall demonstrate by means of physical demonstration testing to the approval authority that the L-category vehicles made available on the market, registered or entering into service in the Union comply with the vehicle construction requirements of Chapter III of Regulation (EU) No 168/2013 and comply with the detailed technical requirements and test procedures laid down in Articles 6 to 20 of this Regulation.
3.Manufacturers shall ensure that spare parts and equipment that are made available on the market or are entering into service in the Union comply with the relevant requirements of Regulation (EU) No 168/2013, as specified by the detailed technical requirements and test procedures referred to in this Regulation. An approved L-category vehicle equipped with such a spare part or equipment shall meet the same test requirements and performance limit values as a vehicle equipped with an original part or equipment satisfying endurance requirements up to and including those set out in Article 22(2) and Articles 23 and 24 of Regulation (EU) No 168/2013.
4.Manufacturers shall also ensure that type-approval procedures for verifying conformity of production are followed with regard to the detailed vehicle construction requirements laid down in Article 33 of Regulation (EU) No 168/2013 and the detailed technical requirements in this Regulation.
5.Where applicable, the manufacturers shall submit to the approval authority a description of the measures taken to prevent tampering with the powertrain management system including the emission and functional safety control computers.