The Member State authorities shall verify one single unit of the model.

The model shall be considered to comply with the applicable requirements if:

1. (a)

   the values given in the technical documentation pursuant to point 2 of Annex IV to Directive 2009/125/EC (declared values), and, where applicable, the values used to calculate these values, are not more favourable for the manufacturer or importer than the results of the corresponding measurements carried out pursuant to paragraph (g) thereof; and

2. (b)

   the declared values meet any requirements laid down in this Regulation, and any required product information published by the manufacturer or importer does not contain values that are more favourable for the manufacturer or importer than the declared values; and

3. (c)

   when the Member State authorities test the unit of the model, the determined values (the values of the relevant parameters as measured in testing and the values calculated from these measurements) comply with the respective verification tolerances as given in Table 10.

If the results referred to in point 2(a) or (b) are not achieved, the model shall be considered not to comply with this Regulation.

If the result referred to in point 2(c) is not achieved, the Member State authorities shall select three additional units of the same model for testing.

The model shall be considered to comply with the applicable requirements if, for these three units, the arithmetical mean of the determined values complies with the respective verification tolerances given in Table 10.

If the result referred to in point 5 is not achieved, the model shall be considered not to comply with this Regulation.

The Member State authorities shall provide all relevant information to the authorities of the other Member States and to the Commission without delay after a decision being taken on the non-compliance of the model according to points 3 and 6.