xmlns:atom="http://www.w3.org/2005/Atom" xmlns:atom="http://www.w3.org/2005/Atom"
Please note that the date you requested in the address for this web page is not an actual date upon which a change occurred to this item of legislation. You are being shown the legislation from , which is the first date before then upon which a change was made.
THE EUROPEAN COMMISSION,
Having regard to the Treaty on the Functioning of the European Union,
Having regard to Regulation (EC) No 595/2009 of the European Parliament and of the Council of 18 June 2009 on type-approval of motor vehicles and engines with respect to emissions from heavy duty vehicles (Euro VI) and on access to vehicle repair and maintenance information and amending Regulation (EC) No 715/2007 and Directive 2007/46/EC and repealing Directives 80/1269/EEC, 2005/55/EC and 2005/78/EC(1), and in particular Article 5(4) thereof,
Whereas:
(1) CEN standards for certain common Fatty Acid Methyl Ester (FAME) diesel blends and paraffinic diesel have recently been published. Therefore, it is appropriate to update the current rules to refer also to those new standards.
(2) In relation to testing with portable emission measurement systems (PEMS), Commission Regulation (EU) 2016/1718(2) introduced requirements on both urban trip share as well as the total trip length. Especially on some N3 category vehicles equipped with an engine with higher power rating, it has been discovered that, due to those limiting requirements, PEMS testing in accordance with the current provisions will result in void tests. In order to resolve the issue, the conditions for compliance with the urban window requirement should be amended, with the urban trip being enlarged at the expense of the motorway trip share and the maximum overall trip length extended.
(3) Clarification is needed regarding the requirement to have at least one valid window in urban only operations applying to NOx emissions specifically, as it is the critical polutant in those conditions.
(4) In case of universal fuel range type-approval, the procedure for demonstrating compliance with the required tolerances for the engine control unit (ECU) torque signal is currently not set out in Commission Regulation (EU) No 582/2011(3). Therefore, when the engine is not equipped with a system to recognise which fuel is being used, the demonstration on how to determine compliance is up to the discretion of the technical service. Due to the increasing interest in type approval of alternative fuels, it is appropriate to harmonise that procedure. The torque deviation caused by the alternative fuel should therefore be determined and the deviation should then be used to calculate a power correction factor, which should be stated in the type approval documentation. The power correction factor may be applied to demonstrate compliance with the ECU torque signal accuracy requirements. Moreover, for PEMS testing with an alternative fuel, the power correction factor may be applied to determine the correct torque value for emission calculations.
(5) Regulation (EU) No 582/2011 should therefore be amended accordingly.
(6) The measures provided for in this Regulation are in accordance with the opinion of the Technical Committee – Motor Vehicles,
HAS ADOPTED THIS REGULATION:
Regulation (EU) No 582/2011 is amended as follows:
Annex I is amended as follows:
in point 1.1.2, the introductory part of the first paragraph is replaced by the following:
‘If the manufacturer permits the engine family to run on market fuels that do not comply either with Directive 98/70/EC of the European Parliament and of the Council(4), or with CEN standard EN 228:2012 in the case of unleaded petrol or CEN standard EN 590:2013 in the case of diesel, such as running on FAME B100 (CEN standard EN 14214), FAME diesel blends B20/B30 (CEN standard EN 16709), paraffinic fuel (CEN standard EN 15940) or others, the manufacturer shall, in addition to the requirements in point 1.1.1, comply with the following requirements:’;
in point 1.1.2, the following point (a1) is inserted:
in point 5.2.5, point (b) is replaced by the following:
the following point 5.2.7 is inserted:
points 5.3.3 and 5.3.3.1 are replaced by the following:
the following point 5.3.3.2 is inserted:
Annex II is amended as follows:
point 4.4.2 is replaced by the following:
The test fuel shall be market fuel covered by Directive 98/70/EC and the relevant CEN standards, or reference fuel as specified in Annex IX to this Regulation.’;
point 4.5.3 is replaced by the following:
point 4.6.5 is replaced by the following:
Appendix 1 is amended as follows:
the following point 4.2.1.1 is inserted:
If a test pursuant to this Annex was performed with a market fuel declared in point 3.2.2.2.1 of Part 1 in Appendix 4 to Annex I, the specific emissions egas (mg/kWh) shall be calculated for each window and each pollutant by multiplication of the uncorrected specific emissions with the power correction factor determined pursuant to point 1.1.2 (a1) of Annex I.’;
in Appendix 4, the following point 2.1.1 is inserted:
This Regulation shall enter into force on the twentieth day following that of its publication in the Official Journal of the European Union.
This Regulation shall be binding in its entirety and directly applicable in all Member States.
Done at Brussels, 29 June 2018.
For the Commission
The President
Jean-Claude Juncker
Commission Regulation (EU) 2016/1718 of 20 September 2016 amending Regulation (EU) No 582/2011 with respect to emissions from heavy-duty vehicles as regards the provisions on testing by means of portable emission measurement systems (PEMS) and the procedure for the testing of the durability of replacement pollution control devices (OJ L 259, 27.9.2016, p. 1).
Commission Regulation (EU) No 582/2011 of 25 May 2011 implementing and amending Regulation (EC) No 595/2009 of the European Parliament and of the Council with respect to emissions from heavy duty vehicles (Euro VI) and amending Annexes I and III to Directive 2007/46/EC of the European Parliament and of the Council (OJ L 167, 25.6.2011, p. 1).
Directive 98/70/EC of the European Parliament and of the Council of 13 October 1998 relating to the quality of petrol and diesel fuels and amending Council Directive 93/12/EEC (OJ L 350, 28.12.1998, p. 58).’;