Please note that the date you requested in the address for this web page is not an actual date upon which a change occurred to this item of legislation. You are being shown the legislation from , which is the first date before then upon which a change was made.

  1. Introductory Text

  2. Article 1.Subject matter and scope

  3. Article 2.Definitions

  4. Article 3.Ecodesign requirements

  5. Article 4.Removal of light sources and separate control gears

  6. Article 5.Conformity assessment

  7. Article 6.Verification procedure for market surveillance purposes

  8. Article 7.Circumvention

  9. Article 8.Indicative benchmarks

  10. Article 9.Review

  11. Article 10.Repeal

  12. Article 11.Entry into force and application

  13. Signature

    1. ANNEX I

      Definitions applicable for the Annexes

      1. The following definitions shall apply:

      2. ‘mains light source (MLS)’ means a light source that can...

    2. ANNEX II

      Ecodesign requirements

      1. For the purposes of compliance and verification of compliance with...

      2. 1. Energy efficiency requirements:

      3. 2. Functional requirements

      4. 3. Information requirements

    3. ANNEX III

      Exemptions

      1. 1. This Regulation shall not apply to light sources and separate...

      2. 2. In addition, this Regulation shall not apply to:

      3. 3. Any light source or separate control gear within the scope...

      4. 4. CLS and CSCG designed and marketed specifically for scene-lighting use...

    4. ANNEX IV

      Verification procedure for market surveillance purposes

      1. The verification tolerances defined in this Annex relate only to...

      2. Where a model has been designed to be able to...

      3. When verifying the compliance of a product model with the...

      4. The Member State authorities shall verify one single unit of...

      5. The authorities of the Member State shall only apply the...

      6. For light sources with linear geometry which are scalable but...

      7. When verifying if a product is a light source, market...

      8. Light sources that allow the end-user to control, manually or...

    5. ANNEX V

      Functionality after endurance testing

      1. Models of LED- and OLED- light sources shall undergo endurance...

      2. The endurance test for LED and OLED light sources shall...

      3. Ambient conditions and test setup: The switching cycles are to...

    6. ANNEX VI

      Benchmarks

      1. For the environmental aspects that were considered significant and are...

      2. The best available technology on the market for light sources...

      3. Mains voltage non-directional light sources: 120-140 lm/W Mains voltage directional...

      4. The best available technology on the market for separate control...

      5. Features required in certain applications, e.g. a high colour rendering,...

      6. The best available technology on the market for light sources...