This is the original version (as it was originally made). This item of legislation is currently only available in its original format.
4. In paragraph 2 of Part 1 (requirements) of Schedule 2—
(a)in sub-paragraph 1(d)—
(i)omit “have a distance of less than 30 metres between the lowest point of the rotating blade of the wind turbine generator and HAT;” and
(ii)insert “not used;”
(b)delete sub-paragraph (2) and insert—
“(2) Within Work No. 1A—
(a)The total rotor swept area must not exceed 1.42 square kilometres; and
(b)the total rotor-swept area and the corresponding air gap for each wind turbine generator must accord with the parameters specified below—
| Where the Total Rotor-Swept Area is | Minimum Air Gap (m) |
|---|---|
| 1.01km2 or less | 30 |
| Greater than 1.01km2 and up to 1.13km2 | 31 |
| Greater than 1.13km2 and up to 1.42km 2 | 32”. |
(c)delete paragraph (3) and insert—
“(3) Within Work No. 1B—
(a)The total rotor swept area must not exceed 1.85 square kilometres; and
(b)the total rotor-swept area and the corresponding air gap for each wind turbine generator must accord with the parameters specified below—
| Where the Total Rotor-Swept Area is | Minimum Air Gap (m) |
|---|---|
| 1.31km2 or less | 30 |
| Greater than 1.31km2 and up to 1.47km2 | 31 |
| Greater than 1.47km2 and up to 1.85km 2 | 32”. |
All content is available under the Open Government Licence v3.0 except where otherwise stated. This site additionally contains content derived from EUR-Lex, reused under the terms of the Commission Decision 2011/833/EU on the reuse of documents from the EU institutions. For more information see the EUR-Lex public statement on re-use.
