- Latest available (Revised)
- Point in Time (01/04/2007)
- Original (As made)
Version Superseded: 28/11/2015
Point in time view as at 01/04/2007. This version of this provision has been superseded.
You are viewing this legislation item as it stood at a particular point in time. A later version of this or provision, including subsequent changes and effects, supersedes this version.
Note the term provision is used to describe a definable element in a piece of legislation that has legislative effect – such as a Part, Chapter or section.
The Water Supply (Water Quality) Regulations (Northern Ireland) 2007, Section 9 is up to date with all changes known to be in force on or before 14 August 2024. There are changes that may be brought into force at a future date. Changes that have been made appear in the content and are referenced with annotations.
Changes and effects yet to be applied by the editorial team are only applicable when viewing the latest version or prospective version of legislation. They are therefore not accessible when viewing legislation as at a specific point in time. To view the ‘Changes to Legislation’ information for this provision return to the latest version view using the options provided in the ‘What Version’ box above.
9.—(1) Subject to paragraph (2), in each year a water undertaker shall take, or cause to be taken—
(a)from its sampling points; or
(b)to the extent authorised by or under regulation 8, from its supply points,
the standard number of samples for analysis as regards residual disinfectant and each parameter listed in column (1) of Table 2 in Schedule 3 or, as the case may be, Table 3 in that Schedule.
(2) Where, in respect of a parameter subject to check monitoring—
(a)a water undertaker is of the opinion that the quality of water supplied by it to a water supply zone is unlikely to deteriorate; and
(b)in each of two successive years the results of samples taken, subject to paragraph (3), in accordance with these Regulations show no significant variation and—
(i)if the parameter is colony counts, have shown no abnormal change;
(ii)if the parameter is hydrogen ion (item 9 in Table 1), have established a pH value that is not less than 6.5 and not more than 10.0;
(iii)in any other case, have established a concentration or value for that parameter that is significantly lower than the prescribed concentration or value, or specification,
the number of samples to be taken in the following year for that parameter may be the reduced number.
(3) Samples required to be taken by this regulation shall be taken at regular intervals.
(4) In this regulation—
(a)in relation to sampling points, residual disinfectant or a parameter and the supply of water to an estimated population within one of the ranges shown in column (2) of Table 2 in Schedule 3, “the standard number” and “the reduced number” means the number shown in column (4) and column (3), respectively, of that Table as applicable to that substance or parameter by reference to a population within that range;
(b)in relation to supply points, each of the parameters specified as items 7, 8 and 9 to 25 in column (1) of Table 3 in Schedule 3, and the supply of a volume of water within one of the ranges shown in column (3) of that Table, “the standard number” and “the reduced number” means, subject to sub-paragraph (c), the number shown in column (5) and column (4), respectively, of that Table as applicable to that parameter by reference to a volume supplied within that range; and
(c)where a particular supply point is in use for part only of a year, “the standard number” and “the reduced number” means the number that bears to the number shown in column (5) and column (4), respectively, of Table 3, the same proportion as the number of days in that year in which the supply point has been in use bears to 365.
Commencement Information
I1Reg. 9 in operation at 1.4.2007, see reg. 1(1)
Latest Available (revised):The latest available updated version of the legislation incorporating changes made by subsequent legislation and applied by our editorial team. Changes we have not yet applied to the text, can be found in the ‘Changes to Legislation’ area.
Original (As Enacted or Made): The original version of the legislation as it stood when it was enacted or made. No changes have been applied to the text.
Point in Time: This becomes available after navigating to view revised legislation as it stood at a certain point in time via Advanced Features > Show Timeline of Changes or via a point in time advanced search.
Geographical Extent: Indicates the geographical area that this provision applies to. For further information see ‘Frequently Asked Questions’.
Show Timeline of Changes: See how this legislation has or could change over time. Turning this feature on will show extra navigation options to go to these specific points in time. Return to the latest available version by using the controls above in the What Version box.
Access essential accompanying documents and information for this legislation item from this tab. Dependent on the legislation item being viewed this may include:
This timeline shows the different points in time where a change occurred. The dates will coincide with the earliest date on which the change (e.g an insertion, a repeal or a substitution) that was applied came into force. The first date in the timeline will usually be the earliest date when the provision came into force. In some cases the first date is 01/02/1991 (or for Northern Ireland legislation 01/01/2006). This date is our basedate. No versions before this date are available. For further information see the Editorial Practice Guide and Glossary under Help.
Use this menu to access essential accompanying documents and information for this legislation item. Dependent on the legislation item being viewed this may include:
Click 'View More' or select 'More Resources' tab for additional information including: