SCHEDULECONDITIONS TO BE INCLUDED IN SITE LICENCES

PART 1OBLIGATIONS IN RESPECT OF KEEPING OR TREATMENT OF WASTE MOTOR VEHICLES

1

F11

No waste motor vehicle shall be kept (even temporarily) unless such keeping–

a

is carried out in accordance with the general requirements laid down in F2sub-paragraph (2) of the Waste Directive; and

b

complies with the minimum technical requirements set out in Part 2 below.

F32

The necessary measures must be taken to ensure that waste management is carried out without endangering human health, without harming the environment and, in particular—

a

without risk to water, air, soil, plants or animals,

b

without causing a nuisance through noise or odours, and

c

without adversely affecting the countryside or places of special interest.

2

No waste motor vehicle shall be treated unless, in respect of the activity or operation performed, that treatment–

a

is carried out in accordance with the general requirements laid down in F4paragraph 1(2) ; and

b

complies with the minimum technical requirements set out in Part 2 below and, where applicable, meets the following obligations–

i

save where it has already been so treated–

aa

the waste motor vehicle shall first be stripped in a way that best reduces any adverse impact on the environment, before any further treatment or other equivalent arrangement is undertaken, and

bb

any of its components or materials which have been labelled or otherwise made identifiable in accordance with regulation 18(2) of the End-of-Life Vehicles Regulations 2003 M1 shall be stripped before any further treatment;

ii

save where it has already been so treated in whole or part, and subject to paragraph (i), depollution of the waste motor vehicle shall be completed as soon as possible;

iii

hazardous materials and components shall be removed from the waste motor vehicle and segregated in such a way so as not to contaminate any part of the vehicle that is subsequently to be shredded; and

iv

any stripping or keeping of the waste motor vehicle shall be carried out in such a way as to ensure the suitability of its components for either reuse or recovery, and in particular recycling.