The Merchant Shipping (Cargo Ship Construction and Survey) Regulations 1984 (Amendment) Regulations 1992

PartIIAA—STABILITY OF SHIPS OF 100M OR OVERCONSTRUCTED ON OR AFTER 1ST FEBRUARY 1992

Interpretation8A

In this Part:—

• “attained subdivision index” means, in relation to a ship, the attained subdivision index of the ship calculated in accordance with regulation 8C.

• “IMO” means the International Maritime Organisation;

• “subdivision length” means, in relation to a ship, the greatest projected moulded length of that part of the ship at or below deck or decks limiting the vertical extent of flooding with the ship at the deepest subdivision load line;

• “subdivision load line” means a waterline used in determining the subdivision of the ship: and “deepest subdivision load line” means the subdivision load line which corresponds to the summer draught to be assigned to the ship.

Application8B

This Part applies to every ship of 100m or over in sub-division length of which the keel was laid or which was at a similar stage of construction on or after 1st February 1992, except:—

a

any United Kingdom ship in respect of which there is in force—

i

a certificate issued pursuant to regulation 7 of the Merchant Shipping (Prevention of Oil Pollution) Regulations 19833, showing that the ship complies with regulation 29 of those Regulations, or

ii

a certificate issued pursuant to regulation 5 of the Merchant Shipping (IBC Code) Regulations 19874, or

iii

a certificate issued pursuant to regulation 5 of the Merchant Shipping (Gas Carriers) Regulations 1986,5, or

iv

a certificate issued pursuant to regulation 5 of the Merchant Shipping (BCH Code) Regulations 19876 showing that the ship complies with Chapter II of that Code, or

v

a document issued by the Secretary of State certifying that the ship complies with the Code for the Construction and Equipment of Ships Carrying Liquefied Gases in Bulk (Gas Carrier Code) (1983 edition) published by IMO, or

vi

a document issued by the Secretary of State, certifying that the ship complies with Chapter 3 of the Guidelines for the Design and Construction of Offshore Supply Vessels annexed to IMO Resolution A.469(XII), or

vii

a document issued by the Secretary of State certifying that the ship complies with the Code of Safety for Special Purpose Ships annexed to IMO Resolution A.534(13), and

b

any United Kingdom ship which complies with the damage stability requirement of paragraph 5 of the Part I of Schedule 5 to the Load Lines Rules 19687; and

c

any ship (other than a United Kingdom ship) which complies with—

i

regulation 25 of Annex 1 to the International Convention for the Prevention of Pollution from Ships 1973/78, or

ii

the International Code for the Construction and Equipment of Ships Carrying Dangerous Chemicals in Bulk (IBC Code) (1990 edition) published by IMO, or

iii

the International Code for the Construction and Equipment of Ships Carrying Liquefied Gases in Bulk (IGC Code) annexed to IMO Resolution MSC.5(48), or

iv

the Code for the Construction and Equipment of Ships Carrying Dangerous Chemicals in Bulk (BCH Code) (1990 edition) published by IMO, or

v

the Code for the Construction and Equipment of Ships Carrying Liquefied Gases in Bulk (Gas Carrier Code) (1983 edition) published by IMO, or

vi

the Guidelines for the Safety and Construction of Offshore Supply Vessels mentioned in paragraph (a)(vi) above, or

vii

the Code for the Safety of Special Purpose Ships mentioned in paragraph (a)(vii) above, or

viii

both with the damage stability requirements of regulation 27 of the International Load Line Convention 1966 as modified by IMO Resolutions A.320(IX) and 514(13) and, in the case of ships to which paragraph (9) of that regulation applies, with paragraph (12)(f) of Resolution A.320(IX).

Subdivision indices8C

1

The attained subdivision index of every ship to which this Part applies shall not be less than the required subdivision index of that ship.

2

The attained subdivision index of a ship is the value “A” calculated in respect of that ship in accordance with the formula specified in paragraph 3 of Annex I of Merchant Shipping Notice No. M1476 and the required subdivision index for a ship, is the value “R” calculated in respect of that ship in accordance with the formula specified in paragraph 2 of Annex Ito that notice.

3

In calculating “A” and “R” regard shall be had to the explanatory notes set out in Annex II to that M Notice.

Stability information8D

1

The master of every ship to which this Part applies shall be supplied with such reliable information as is necessary to enable him by rapid and simple means to determine the stability of the ship under varying conditions of service.

2

That information shall include:—

a

One of the following:—

i

a curve of minimum operational metacentric height (GM)

versus draught which assures compliance with the applicable intact stability requirements of Schedule 4 Part I to the Merchant Shipping (Load Lines) Rules 1968 or with the attained subdivision index of the ship, whichever is the more onerous condition or, where curves representing the requirements cross the part of each curve which represents the more onerous requirement; or

ii

a (corresponding)

curve of the maximum allowable vertical centre of gravity (KG) versus draught; or

iii

a tabular or equivalent presentation of either of these curves; and

b

instructions concerning the operation of cross-flooding arrangements; and

c

all other data and means of presentation necessary to assist the crew to maintain stability after damage.

3

Where the curve provided or presented in compliance with regulation 8D(2)(a) is based wholly or in part on the attained subdivision index ofthe ship the operational GM(KG) values shall be applied in the manner and to the extent specified in paragraph 7 of Annex I to Merchant Shipping Notice No. M1476;

4

a

The information required to be supplied by this regulation shall, before it is supplied to the master, be submitted for approval to that Assigning Authority to which the information supplied in respect of the ship pursuant to rule 30 of the Merchant Shipping (Load Line) Rules 19688 is required to be submitted in accordance with paragraph (5) of that rule. The information shall incorporate such additions and amendments as the Assigning Authority may specify for the purpose of ensuring that it complies with the provisions of this regulation.

b

In this paragraph, “Assigning Authority” has the same meaning as in the Merchant Shipping (Load Line) Rules 1968.

5

There shall be permanently exhibited or readily available on the navigating bridge for the guidance of the officer in charge of the ship, plans showing clearly for each deck and hold the boundaries of the watertight compartments, the openings therein, the means of closure and position of any controls thereof, and the arrangements for the correction of any list due to flooding. In addition, booklets containing the aforementioned information shall be made available by the owners for the use of the officers of the ship.

Openings in watertight bulkheads and internal decks8E

1

The number of openings in the boundaries of watertight compartments shall be the minimum compatible with the design and proper working of the ship. Where penetration of watertight bulkheads and internal decks is necessary for access, piping, ventilation, electrical cables, or for any other purpose, arrangements shall be made to maintain watertight integrity at each such point of penetration. The Certifying Authority may permit openings in compartment boundaries above the free board deck to be weathertight rather than watertight where it is demonstrated that any progressive flooding resulting therefrom could be easily controlled and that safety of the ship would not be thereby impaired.

2

Doors provided to ensure the watertight integrity of internal openings which are used while the ship is at sea shall be of the sliding watertight type and capable of being remotely closed from the bridge and capable also of being operated locally from each side of the door without automatic closure of the door. Indicators shall be provided at the bridge position showing whether the doors are open or closed, and an audible alarm shall be provided at the door closure. The power for operating and controlling the doors, indicators and alarms shall be supplied from the emergency switchboard required by regulation 45. The control system shall be so designed that if the system fails closure by hand will not be prevented or impeded. Each power-operated sliding watertight door shall be provided with an individual hand-operated opening and closing mechanism. Means shall be provided at the door itself to open and close the door safely by hand from both sides and from an accessibleposition above the bulkhead deck.

3

Access doors and access hatch covers normally closed at sea and intended to ensure the watertight integrity of internal openings, shall be provided with means of indication locally and on the bridge showing whether these doors or hatch covers are open or closed. A notice shall be affixed to each such door or hatch cover stating that it is not to be left open at sea. Such doors and hatch covers shall not be used except where access is necessary and is authorised by the officer of the watch.

4

Watertight doors or ramps of satisfactory construction may be fitted to subdivide large cargo spaces internally where the Certifying Authority is satisfied that such doors or ramps are essential. Such doors or ramps may be of the hinged, rolling or sliding type, but shall not be remotely controlled. Such doors or ramps shall be closed before the voyage commences and shall be kept closed throughout the voyage. The time of opening such doors or ramps when the voyage has ended and of closing them before the voyage commences shall be entered in the log book. Any doors or ramps which may be accessible during the voyage shall be fitted with a device which prevents unauthorised opening.

5

Every closing appliance which is required to be kept permanently closed at sea to ensure the watertight integrity of a compartment shall be provided with a notice affixed to it stating that it is to be kept closed; provided that manholes secured by closely bolted covers need not be so marked.

External openings8F

1

All external openings which lead to compartments assumed intact for the purposes of calculating the subdivision index “A”, and which are below the final damage waterlines, shall be watertight.

2

External openings required to be watertight in accordance with paragraph (1) shall be of sufficient strength and, except in the case of cargo hatch covers,shall be fitted with indicators on the bridge.

3

Openings in the shell plating below the deck limiting the vertical extent of damage shall be kept permanently closed while at sea. Any of these openings which may be accessible during the voyage, shall be fitted with a device which prevents unauthorised opening.

4

Notwithstanding the requirements of paragraph (3), the Certifying Authority may authorise the opening of specific doors, at the discretion of the master, if it is satisfied that such opening is necessary for the operation of the ship and provided that the safety of the ship would not be thereby impaired.

5

Every watertight closing appliance which is required to be permanently closed at sea to ensure the integrity of an external opening shall be provided with a notice affixed to it stating that it is to be kept closed at sea: provided that manholes secured by closely bolted covers need not be so marked.