PART 3General prohibitions and obligations
Conformity assessment procedures
Annex IV machinery not manufactured fully in accordance with F1designated standards or not fully covered by such standardsE112
1
This regulation applies to machinery—
a
which falls within a category which is referred to in Annex IV (Part 4 of Schedule 2); and
b
in respect of which any of the following conditions is satisfied—
i
that the machinery is not manufactured in accordance with the F4designated standards which relate to it; or
ii
that the machinery is only partly manufactured in accordance with the F4designated standards which relate to it; or
iii
that the F4designated standards in accordance with which the machinery is manufactured do not cover all the applicable essential health and safety requirements; or
iv
that no F2designated standards exist for the machinery.
2
Where this regulation applies, the responsible person shall follow one of the following conformity assessment procedures—
a
the F3Type- examination procedure prescribed in Annex IX (Part 9 of Schedule 2) and the internal checks on the manufacture of machinery prescribed in Annex VIII (Part 8 of Schedule 2), point 3; or
b
the full quality assurance procedure prescribed in Annex X (Part 10 of Schedule 2).
Annex IV machinery not manufactured fully in accordance with published harmonised standards or not fully covered by such standardsE212
1
This regulation applies to machinery—
a
which falls within a category which is referred to in Annex IV (Part 4 of Schedule 2); and
b
in respect of which any of the following conditions is satisfied—
i
that the machinery is not manufactured in accordance with the published harmonised standards which relate to it; or
ii
that the machinery is only partly manufactured in accordance with the published harmonised standards which relate to it; or
iii
that the published harmonised standards in accordance with which the machinery is manufactured do not cover all the applicable essential health and safety requirements; or
iv
that no harmonised standards exist for the machinery.
2
Where this regulation applies, the responsible person shall follow one of the following conformity assessment procedures—
a
the EC type-examination procedure prescribed in Annex IX (Part 9 of Schedule 2) and the internal checks on the manufacture of machinery prescribed in Annex VIII (Part 8 of Schedule 2), point 3; or
b
the full quality assurance procedure prescribed in Annex X (Part 10 of Schedule 2).