2018 No. 1230
The Building (Amendment) Regulations 2018
Made
Laid before Parliament
Coming into force
The Secretary of State has consulted the Building Regulations Advisory Committee for England and such other bodies as appeared to him to be representative of the interests concerned in accordance with section 14(3) of the Building Act 19841.
The Secretary of State makes the following Regulations in exercise of the powers conferred by section 1 of, and paragraphs 7, 8 and 10 of Schedule 1 to, the Building Act 19842.
Citation, extent, application and commencement1
1
These Regulations may be cited as the Building (Amendment) Regulations 2018.
2
These Regulations extend to England and Wales.
3
These Regulations do not apply to any building in Wales.
4
These Regulations come into force on 21st December 2018.
Amendments to the Building Regulations 20102
1
The Building Regulations 20103 are amended in accordance with the following paragraphs.
2
In regulation 2 (interpretation) after paragraph (5) insert—
6
In these Regulations—
a
any reference to an “external wall” of a building includes a reference to—
i
anything located within any space forming part of the wall;
ii
any decoration or other finish applied to any external (but not internal) surface forming part of the wall;
iii
any windows and doors in the wall; and
iv
any part of a roof pitched at an angle of more than 70 degrees to the horizontal if that part of the roof adjoins a space within the building to which persons have access, but not access only for the purpose of carrying out repairs or maintenance; and
b
“specified attachment” means—
i
a balcony attached to an external wall;
ii
a device for reducing heat gain within a building by deflecting sunlight which is attached to an external wall; or
iii
a solar panel attached to an external wall.
3
In regulation 4(2) (requirements relating to building work) after “Schedule 1” insert “(in addition to the requirements of regulation 7)”.
4
In regulation 5 (meaning of material change of use)—
a
after paragraph (i) omit “or”; and
b
after paragraph (j) insert—
; or
k
the building is a building described in regulation 7(4)(a), where previously it was not
5
In regulation 6 (requirements relating to material change of use) after paragraph (2) insert—
3
Subject to paragraph (4), where there is a material change of use described in regulation 5(k), such work, if any, shall be carried out as is necessary to ensure that any external wall, or specified attachment, of the building only contains materials of European Classification A2-s1, d0 or A1, classified in accordance with BS EN 13501-1:2007+A1:2009 entitled “Fire classification of construction products and building elements. Classification using test data from reaction to fire tests” (ISBN 978 0 580 59861 6) published by the British Standards Institution on 30th March 2007 and amended in November 2009.
4
Paragraph (3) does not apply to the items listed in regulation 7(3).
6
Regulation 7 (materials and workmanship) is renumbered as paragraph (1) of that regulation.
7
After regulation 7(1) (as renumbered) insert—
2
Subject to paragraph (3), building work shall be carried out so that materials which become part of an external wall, or specified attachment, of a relevant building are of European Classification A2-s1, d0 or A1, classified in accordance with BS EN 13501-1:2007+A1:2009 entitled “Fire classification of construction products and building elements. Classification using test data from reaction to fire tests” (ISBN 978 0 580 59861 6) published by the British Standards Institution on 30th March 2007 and amended in November 2009.
3
Paragraph (2) does not apply to—
a
cavity trays when used between two leaves of masonry;
b
any part of a roof (other than any part of a roof which falls within paragraph (iv) of regulation 2(6)) if that part is connected to an external wall;
c
door frames and doors;
d
electrical installations;
e
insulation and water proofing materials used below ground level;
f
intumescent and fire stopping materials where the inclusion of the materials is necessary to meet the requirements of Part B of Schedule 1;
g
membranes;
h
seals, gaskets, fixings, sealants and backer rods;
i
thermal break materials where the inclusion of the materials is necessary to meet the thermal bridging requirements of Part L of Schedule 1; or
j
window frames and glass.
4
In this regulation—
a
a “relevant building” means a building with a storey (not including roof-top plant areas or any storey consisting exclusively of plant rooms) at least 18 metres above ground level and which—
i
contains one or more dwellings;
ii
contains an institution; or
iii
contains a room for residential purposes (excluding any room in a hostel, hotel or boarding house); and
b
“above ground level” in relation to a storey means above ground level when measured from the lowest ground level adjoining the outside of a building to the top of the floor surface of the storey.
Transitional provisions3
1
The amendments made by regulation 2 do not apply in any case where a building notice or an initial notice has been given to, or full plans deposited with, a local authority before the day these Regulations come into force and either the building work to which it relates—
a
has started before that day; or
b
is started within the period of two months beginning on that day.
2
In this regulation, “building notice”, “initial notice” and “full plans” have the meanings given in the Building Regulations 2010.
Signed by authority of the Secretary of State for Housing, Communities and Local Government
(This note is not part of the Regulations)