- Latest available (Revised)
- Original (As made)
This is the original version (as it was originally made).
309. Commission Implementing Regulation (EU) No 1079/2012 of 16 November 2012 laying down requirements for voice channels spacing for the single European sky is amended in accordance with regulations 310 to 327.
310. In Article 2 (scope), in paragraph 3, for “Member States are” substitute “the United Kingdom is”.
311. In Article 3 (definitions), in point 6 after “given by” insert “the CAA or”.
312.—(1) Article 4 (interoperability and performance requirements of radio equipment) is amended as follows.
(2) In paragraph 1—
(a)after “or” insert “if the manufacturer is not established in the United Kingdom”,
(b)for “Union” substitute “United Kingdom”, and
(c)omit “from 17 November 2013”.
(3) In paragraph 3—
(a)for “Member States” substitute “The CAA”, and
(b)after “issued in the” insert “United Kingdom or European”.
(4) In paragraph 4 omit “from 17 November 2013”.
(5) In paragraph 5—
(a)for “Member States” substitute “The CAA”, and
(b)omit “by 31 December 2017 at the latest”.
313.—(1) Article 5 (obligations of operators) is amended as follows.
(2) In paragraph 2—
(a)for “From 1 January 2014 an” substitute “An”, and
(b)after “class A, B or C of the” insert “under the responsibility of the United Kingdom or the”.
(3) In paragraph 4 omit “from 1 January 2018”.
314.—(1) Article 6 (requirements on 8,33 kHz conversions) is amended as follows.
(2) In paragraph 1 for “Member States” substitute “The CAA”.
(3) In paragraph 2—
(a)for “Member States” substitute “the CAA”, and
(b)for “the Commission” substitute “Eurocontrol”.
(4) Omit paragraphs 3 to 7.
(5) In paragraph 8—
(a)for “Member States listed in Annex I” substitute “The CAA”, and
(b)omit “from 1 January 2015,”.
(6) In paragraph 9—
(a)for “Member States” substitute “CAA”, and
(b)for “Commission, by 31 December 2014 at the latest,” substitute “Secretary of State”.
(7) In paragraph 10—
(a)for “Member States” substitute “The CAA”, and
(b)omit “, by 31 December 2018 at the latest,”.
315. In Article 8 (associated procedures) omit paragraph 7.
316.—(1) Article 9 (arrangements for State aircraft) is amended as follows.
(2) In paragraph 1 for “Member States” substitute “The Secretary of State”.
(3) In paragraph 2—
(a)for “Member States” substitute “the Secretary of State”, and
(b)omit “by 31 December 2012 at the latest”.
(4) In each of paragraphs 3 and 4 for “Member States” substitute “The Secretary of State”.
(5) In paragraph 5—
(a)for “Member States” substitute “the Secretary of State”, and
(b)omit “by 31 December 2015 at the latest”.
(6) In paragraph 6—
(a)for “Member States” substitute “The Secretary of State”, and
(b)omit “from 1 January 2014”.
(7) In paragraph 7—
(a)for “Member States” substitute “The Secretary of State”, and
(b)omit “from 1 January 2014”.
(8) In paragraph 8—
(a)for “Member States” substitute “The Secretary of State”, and
(b)omit “by 31 December 2018 at the latest”.
(9) Omit paragraphs 9 and 10.
(10) In paragraph 13 for “Member States” substitute “The CAA”.
(11) In paragraph 14 for “Member State that has designated them” substitute “CAA”.
317. In Article 10 (safety requirements) for “Member States” substitute “The CAA”.
318. In Article 11 (conformity or suitability for use of constituents), in each of paragraphs 1 and 2, for “an EC” substitute “a”.
319.—(1) Article 12 (verification of systems) is amended as follows.
(2) In paragraph 1 for “their national supervisory authority” substitute “the CAA”.
(3) In paragraph 2 for “a notified” substitute “an appointed”.
(4) In paragraph 3 for “an EC” substitute “a”.
320.—(1) Article 13 (additional requirements) is amended as follows.
(2) In paragraph 1 for “Member States” substitute “The CAA”.
(3) Omit paragraphs 2 and 4.
(4) In paragraph 6 for “Member States” substitute “The CAA”.
321.—(1) Article 14 (exemptions) is amended as follows.
(2) In paragraph 1—
(a)for “the first paragraph of Article 4 of Commission Regulation (EC) No 730/2006,” substitute “point SERA.5005(d)(2) of the Annex to Commission Implementing Regulation (EU) No 923/2012”, and
(b)for “Member States” substitute “the CAA”.
(3) In paragraph 2—
(a)for “Member States” substitute “The CAA”, and
(b)omit “local”.
(4) In paragraph 3—
(a)for “Member States” substitute “The CAA, if”,
(b)omit “local”, and
(c)for “the Commission” substitute “Eurocontrol”.
(5) Omit paragraph 4.
322. Omit Article 15 (repeal).
323. Omit Article 16 (entry into force).
324. After Article 16 omit the sentence which begins “This Regulation shall be binding”.
325.—(1) Annex 1 (Member States referred to in Articles 5 and 6) is amended as follows.
(2) In the heading for “Articles 5 and 6” substitute “Article 5”.
(3) In the text before the indented list for “Articles 5(2), 6(3), 6(5) and 6(8)” substitute “Article 5(2)”.
(4) Omit the last indent (United Kingdom).
326.—(1) Annex 3 (requirements referred to in Article 10, to be taken into consideration during the safety assessment) is amended as follows.
(2) In point 4 omit “(2),”.
(3) In each of points 5 and 6 for “Member States” substitute “The CAA”.
(4) In point 9, for the words from “Member States” to “shall” substitute “If the CAA converts frequency assignments to 8,33 kHz channel spacing in any part of the airspace under the responsibility of the United Kingdom it must:”.
327.—(1) Annex 4 is amended as follows.
(2) In Part B (internal production control module)—
(a)in point 1—
(i)after “manufacturer or”, in both places those words occur, insert “, if the manufacturer is not established in the United Kingdom”, and
(ii)for “Union”, in both places it occurs, substitute “United Kingdom”,
(b)in point 2—
(i)for “He or his” substitute “The manufacturer, or if the manufacturer is not established in the United Kingdom, the manufacturer’s”,
(ii)for “Union”, in both places it occurs, substitute “United Kingdom”,
(iii)for “relevant national supervisory authorities” substitute “CAA”,
(iv)after “manufacturer or” insert “, if the manufacturer is not established in the United Kingdom”, and
(v)for “Member States” substitute “CAA”,
(c)in point 3—
(i)for “Union”, in both places it occurs, substitute “United Kingdom”, and
(ii)for “Member States” substitute “CAA”, and
(d)in point 5 after “manufacturer or” insert “, if the manufacturer is not established in the United Kingdom”.
(3) In Part C (requirements for the verification of systems referred to in Article 12(1)), in point 7—
(a)omit “EC” in the first place it occurs, and
(b)for “national supervisory authority” substitute “CAA”.
(4) In Part D (requirements for the verification of systems referred to in Article 12(2))—
(a)in point 5 for “a notified” substitute “an appointed”,
(b)in each of points 6 to 8 for “notified” substitute “appointed”, and
(c)in point 9—
(i)omit “EC” in the first place it occurs, and
(ii)for “national supervisory authority” substitute “CAA”.
The Whole Instrument you have selected contains over 200 provisions and might take some time to download. You may also experience some issues with your browser, such as an alert box that a script is taking a long time to run.
Would you like to continue?
The Whole Instrument you have selected contains over 200 provisions and might take some time to download.
Would you like to continue?
The Whole Instrument without Schedules you have selected contains over 200 provisions and might take some time to download. You may also experience some issues with your browser, such as an alert box that a script is taking a long time to run.
Would you like to continue?
The Whole Instrument without Schedules you have selected contains over 200 provisions and might take some time to download.
Would you like to continue?
The Whole Part you have selected contains over 200 provisions and might take some time to download. You may also experience some issues with your browser, such as an alert box that a script is taking a long time to run.
Would you like to continue?
The Whole Part you have selected contains over 200 provisions and might take some time to download.
Would you like to continue?
The Whole Instrument you have selected contains over 200 provisions and might take some time to download. You may also experience some issues with your browser, such as an alert box that a script is taking a long time to run.
Would you like to continue?
Latest Available (revised):The latest available updated version of the legislation incorporating changes made by subsequent legislation and applied by our editorial team. Changes we have not yet applied to the text, can be found in the ‘Changes to Legislation’ area.
Original (As Enacted or Made): The original version of the legislation as it stood when it was enacted or made. No changes have been applied to the text.
Explanatory Memorandum sets out a brief statement of the purpose of a Statutory Instrument and provides information about its policy objective and policy implications. They aim to make the Statutory Instrument accessible to readers who are not legally qualified and accompany any Statutory Instrument or Draft Statutory Instrument laid before Parliament from June 2004 onwards.
Access essential accompanying documents and information for this legislation item from this tab. Dependent on the legislation item being viewed this may include:
Use this menu to access essential accompanying documents and information for this legislation item. Dependent on the legislation item being viewed this may include:
Click 'View More' or select 'More Resources' tab for additional information including: