SCHEDULE 2AMENDMENTS TO COMMISSION REGULATIONS RELATED TO ECODESIGN

Commission Regulation (EC) No 1275/2008I11

1

Commission Regulation (EC) No 1275/2008 of 17 December 2008 implementing Directive 2005/32/EC of the European Parliament and of the Council with regard to ecodesign requirements for standby and off mode, and networked standby, electric power consumption of electrical and electronic household and office equipment is amended as follows.

2

Article 2 (definitions) is amended as follows—

a

at the beginning, for the words from “For the purposes” to “also apply:”, substitute—

The definitions set out in the Ecodesign for Energy-Related Products Regulations 2010 M1 apply; and for any term that is not defined in those Regulations, the definitions set out in Directive 2009/125/EC of the European Parliament and of the Council of 21 October 2009 establishing a framework for the setting of ecodesign requirements for energy-related products M2, as it had effect immediately before F1IP completion day, apply. The following definitions also apply—

b

for the definition of “off mode” in paragraph 6, substitute—

6

‘off mode’ means a condition in which the equipment is connected to a mains power source and is not providing any function other than—

a

an indication of off mode condition; or

b

functionalities intended only to ensure electromagnetic compatibility pursuant to the Electromagnetic Compatibility Regulations 2016 M3;

3

For Article 4 (conformity assessment), substitute—

For the purposes of regulation 4(2)(a) of the Ecodesign for Energy-Related Products Regulations 2010, the procedure for assessing whether an energy-related product complies with this implementing measure is the internal design control system set out in Part 1 of Schedule 1A to the Ecodesign for Energy-Related Products Regulations 2010 or the management system for assessing conformity set out in Part 2 of Schedule 1A to those Regulations.

4

Omit Article 7 (revision).

5

At the end of Article 8 (entry into force), omit “This Regulation shall be binding in its entirety and directly applicable in all Member States.”.

6

Annex 3 (product compliance verification by market surveillance authorities) is amended as follows—

a

in each instance, for “Member State” or “Member States”, substitute “F2Great Britain”;

b

in section 1—

i

for the first paragraph, substitute—

When verifying the compliance of a product model with the requirements laid down in this Regulation, for the requirements referred to in this Annex the authorities of F3Great Britain must apply the following procedure—

ii

in subparagraph (2)(a)—

aa

for “point 2 of Annex IV to Directive 2009/125/EC (declared values)” substitute “ paragraph 1(2) of Part 1 of Schedule 1A to the Ecodesign for Energy-Related Products Regulations 2010 ”; and

bb

for “paragraph (g) thereof”, substitute “ paragraph 1(2)(b)(vii) of Part 1 of Schedule 1A to those Regulations ”;

iii

subparagraph (7) is omitted;

iv

in the second paragraph—

aa

for “7” substitute “ 6 ”; and

bb

for “harmonised” substitute “ designated ”.

7

Annex 4 (benchmarks) is amended as follows—

a

in the first paragraph, for “purpose of Annex I, Part 3, point 2, to Directive 2005/32/EC” substitute “ purposes of this Regulation ”; and

b

in the second paragraph, for “Directive 2004/108/EC”, substitute “ the Electromagnetic Compatibility Regulations 2016 ”.