Commission Regulation (EC) No 244/2009U.K.
3.—(1) Commission Regulation (EC) No 244/2009 of 18 March 2009 implementing Directive 2005/32/EC of the European Parliament and of the Council with regard to ecodesign requirements for non-directional household lamps is amended as follows.
(2) In Article 2 (definitions), at the beginning, for the words from “For the purposes” to “also apply:”, substitute—
“The definitions set out in the Ecodesign for Energy-Related Products Regulations 2010 apply; and for any term that is not defined in those Regulations, the definitions set out in Directive 2009/125/EC of the European Parliament and of the Council of 21 October 2009 establishing a framework for the setting of ecodesign requirements for energy-related products, as it had effect immediately before [F1IP completion day], apply. The following definitions also apply—”.
(3) In Article 4 (conformity assessment)—
(a)for paragraph 1, substitute—
“1. For the purposes of regulation 4(2)(a) of the Ecodesign for Energy-Related Products Regulations 2010, the procedure for assessing whether an energy-related product complies with this implementing measure is the internal design control system set out in Part 1 of Schedule 1A to the Ecodesign for Energy-Related Products Regulations 2010 or the management system for assessing conformity set out in Part 2 of Schedule 1A to those Regulations.”;
(b)in paragraph 2, for “Article 8 of Directive 2005/32/EC” substitute “ regulation 4(2)(a) of the Ecodesign for Energy-Related Products Regulations 2010 ”.
(4) For Article 5 (verification procedure for market surveillance purposes), substitute—
“When performing market surveillance checks to assess compliance with the requirements set out in Annex 2, the authorities of [F2Great Britain] must apply the verification procedure described in Annex 3.”.
(5) Omit Article 7 (revision).
(6) At the end of Article 8 (entry into force), omit “This Regulation shall be binding in its entirety and directly applicable in all Member States.”.
(7) In Annex 1 (technical parameters covered and definitions for the purposes of Annexes 2 to 4), in the definition of “lamp mercury content” after “Commission Decision 2002/747/EC”, insert “ , as it had effect immediately before [F1IP completion day] ”.
(8) In Annex 2 (ecodesign requirements for non-directional household lamps), in paragraph 3.1(a), after “Directive 98/11/EC M1”, insert “ , as it had effect immediately before [F1IP completion day] ”.
(9) Annex 3 (verification procedure for market surveillance purposes) is amended as follows—
(a)in the first paragraph, for “Member State”, substitute “[F3Great Britain]”;
(b)in the fourth paragraph—
(i)for “authorities of the Member States”, substitute “ [F4Great Britain] authorities ”;
(ii)in the first point, for the words from “harmonised” to “Directive 2005/32/EC”, substitute “ designated standards ”.
Textual Amendments
F1Words in Regulations substituted (31.12.2020 immediately before IP completion day) by The Ecodesign for Energy-Related Products and Energy Information (Amendment) (EU Exit) Regulations 2020 (S.I. 2020/1528), regs. 1(2), 4
F2Words in Sch. 2 para. 3(4) substituted (31.12.2020 immediately before IP completion day) by The Ecodesign for Energy-Related Products and Energy Information (Amendment) (EU Exit) Regulations 2020 (S.I. 2020/1528), regs. 1(2), 6(3)(4)(b)(iii)
F3Words in Sch. 2 para. 3(9)(a) substituted (31.12.2020 immediately before IP completion day) by The Ecodesign for Energy-Related Products and Energy Information (Amendment) (EU Exit) Regulations 2020 (S.I. 2020/1528), regs. 1(2), 6(1)(2)(b)(iii)
F4Words in Sch. 2 para. 3(9)(b)(i) substituted (31.12.2020 immediately before IP completion day) by The Ecodesign for Energy-Related Products and Energy Information (Amendment) (EU Exit) Regulations 2020 (S.I. 2020/1528), regs. 1(2), 6(1)(2)(b)(iii)
Commencement Information
I1Sch. 2 para. 3 in force at 31.12.2020 on IP completion day (in accordance with 2020 c. 1, Sch. 5 para. 1(1)), see reg. 1(3)
Marginal Citations
M1OJ L 71, 10.3.1998, p. 1.