The Ecodesign for Energy-Related Products and Energy Information (Amendment) (EU Exit) Regulations 2020

Amendments to the Ecodesign for Energy-Related Products and Energy Information (Amendment) (EU Exit) Regulations 2019

8.  In Schedule 2—

(a) omit paragraph 5 (amendment of Commission Regulation (EC) No 278/2009);

(b) in paragraph 19 (amendment of Commission Regulation (EU) No 813/2013, in sub-paragraph (4)(b)—

(i) omit the inserted paragraph 4(b)(i);

(ii) after the inserted paragraph 4(b) insert—

“(ba) for “the Community”, in the first four places it occurs, there were substituted “Great Britain”;”;

(iii) after paragraph 4(e) insert—

“(f) in paragraph 9, for “the Community market” there were substituted “the market of Great Britain”;”;

(iv) omit the inserted paragraph 5(b)(i);

(v) after the inserted paragraph (5)(b) insert—

“(ba) in the description of Module C: Conformity to type, in paragraph 3—

(i) for “the Community”, in the first place it occurs, there were substituted “Great Britain”;

(ii) for “the Community market” there were substituted “the market of Great Britain”;

(bb) for “the Community”, in each other place it occurs, there were substituted “Great Britain”;”;

(c) in paragraph 22 (amendment of Commission Regulation (EU) No 548/2014)—

(i) after sub-paragraph (1) insert—

“(1A) In Article 1 (subject matter and scope)—

(a) in paragraph 2(l), for “Directive 94/9/EC of the European Parliament and of the Council” substitute “the Equipment and Protective Systems Intended for Use in Potentially Explosive Atmospheres Regulations 2016”(1);

(b) in paragraph 2(o), for “Article 3 of Council Directive 2009/71/Euratom” substitute “section 26 of the Nuclear Installations Act 1965”(2);

(c) in paragraph 3, omit “This is without prejudice to the legal obligations under other Union’s harmonisation legislation that these products could be subject to”.”;

(ii) in sub-paragraph (2)—

(aa) for “In Article 2 (definitions),” substitute—

“In Article 2 (definitions)—

(a)”;

(bb) after sub-paragraph (2)(a) insert—

“(b) In point (17), for “point 2 of Annex IV to Directive 2009/125/EC” substitute “paragraph 1(2)(b) of Schedule 1A to the Ecodesign for Energy-Related Products Regulations 2010”(3).”;

(iii) after sub-paragraph (2) insert—

“(2A) In Article 3 (eco-design requirements), omit the second paragraph.”.”;

(iv) in sub-paragraph (3)—

(aa) for “For Article 4 (conformity assessment) substitute—” substitute—

• “In Article 4 (conformity assessment)—

(a) for paragraph 1, substitute—”;

(bb) after sub-paragraph (3)(a), insert—

“(b) in paragraph 2, for “Article 8 of Directive 2009/125/EC” substitute “regulation 4(2)(a) of the Ecodesign for Energy-Related Products Regulations 2010.”(4).”;

(v) in sub-paragraph (4), for “the United Kingdom” substitute “Great Britain”;

(vi) in sub-paragraph (6), for “Article 8” substitute “Article 9”;

(vii) for sub-paragraph (7) substitute—

“(7) In Annex 2 (measurement and calculation methods)—

(a) in the first paragraph, omit the words from “including” to “Union”;

(b) the second paragraph, for “relevant harmonised standards” substitute “designated standards”.(5)”;

(viii) in sub-paragraph (8)—

(aa) in paragraph (a), for “United Kingdom” substitute “Great Britain”;

(bb) in paragraph (b), for “the second paragraph” substitute “the third paragraph”, and for “the United Kingdom” substitute “Great Britain”;

(cc) after paragraph (b) insert—

“(ba) in the final paragraph of point (1), omit the words from “The Member State authorities” to “non-compliance of the model”.”.

(dd) in paragraph (e), for “the fourth paragraph” substitute “the fifth paragraph”.

(1)

S.I. 2016/1107.

(2)

1965 c. 57.

(3)

S.I. 2010/2617; Schedule 1A was inserted by S.I. 2019/539.

(4)

Regulation 4(2) was amended by S.I. 2019/539.

(5)

See regulations 2 and 2A of S.I. 2010/2617 (as amended by S.I. 2019/539) for the meaning of “designated standard”; that definition applies to Commission Regulation (EU) No 548/2014 by virtue of paragraph 22(2) of Schedule 2 to S.I. 2019/539.