Search Legislation

The Food and Feed Regulated Products (Miscellaneous Amendments) (Wales) (EU Exit) Regulations 2019

 Help about what version

What Version

 Help about advanced features

Advanced Features

Changes over time for: Section 3

 Help about opening options

Alternative versions:

Status:

Point in time view as at 31/12/2020.

Changes to legislation:

There are currently no known outstanding effects for the The Food and Feed Regulated Products (Miscellaneous Amendments) (Wales) (EU Exit) Regulations 2019, Section 3. Help about Changes to Legislation

Close

Changes to Legislation

Revised legislation carried on this site may not be fully up to date. At the current time any known changes or effects made by subsequent legislation have been applied to the text of the legislation you are viewing by the editorial team. Please see ‘Frequently Asked Questions’ for details regarding the timescales for which new effects are identified and recorded on this site.

The Materials and Articles in Contact with Food (Wales) Regulations 2012E+W

3.—(1) The Materials and Articles in Contact with Food (Wales) Regulations 2012 M1 are amended as follows.

(2) In regulation 2(1), omit the definition of “Directive 84/500/EEC”.

[F1(2A) In regulation 4(3) omit “Community”.

(2B) In regulation 6(1)—

(a)omit sub-paragraph (a);

(b)in sub-paragraph (b), for “16(1)” substitute “16”.]

(3) In regulation 9, omit paragraph (b).

(4) For regulation 10 substitute—

10.(1) The quantities of lead and cadmium transferred from a ceramic article must not exceed the limits set out in paragraph (5) as read with paragraphs (4) and (6).

(2) Unless it is demonstrated that the materials used to make the ceramic article did not contain lead or cadmium, the quantities of lead and cadmium transferred from a ceramic article must be determined by means of a test, the conditions of which are specified in Schedule 3, using the method of analysis described in Schedule 4.

(3) No person may place on the market a ceramic article that does not comply with the requirements of paragraph (1) as read with paragraph (2).

(4) Where a ceramic article consists of a vessel fitted with a ceramic lid, the lead or cadmium limits (or both) which may not be exceeded (mg/dm2 or mg/litre) must be that which applies to the vessel alone. The vessel alone and the inner surface of the lid must be tested separately and under the same conditions. The sum of the two lead or cadmium extraction levels obtained by this method must be related as appropriate to the surface area or the volume of the vessel alone.

(5) A ceramic article is to be recognised as satisfying the requirements of these Regulations relating to such articles if the quantities of lead and/or cadmium extracted during the test carried out under the conditions laid down in Schedule 3 and Schedule 4 do not exceed the following limits—

Lead (Pb)Cadmium (Cd)
Category 1: Articles which cannot be filled and articles which can be filled, the internal depth of which, measured from the lowest point to the horizontal plane passing through the upper rim, does not exceed 25 mm0,8 mg/dm20,07 mg/dm2

Category 2:

All other articles which can be filled

4,0 mg/l0,3 mg/l
Category 3: Cooking ware; packaging and storage vessels having a capacity of more than three litres1,5 mg/l0,1 mg/l

(6) However, where a ceramic article does not exceed the above quantities by more than 50%, that article is nevertheless to be recognised as satisfying the requirements of these Regulations relating to such articles if at least three other articles with the same shape, dimensions, decoration and glaze are subjected to a test carried out under the conditions laid down in Schedule 3 and Schedule 4 and the average quantities of lead and/or cadmium extracted from those articles do not exceed the limits set, with none of those articles exceeding those limits by more than 50%.

(5) After regulation 10 insert—

10A.(1) A person who places on the market a ceramic article which is not yet in contact with foodstuffs must provide a written declaration [F2complying with paragraph (2)] to accompany the article at the marketing stages up to and including the retail stage.

(2) The declaration must be issued by the manufacturer or by a seller in [F3Great Britain] and must contain the information laid down in Schedule 5.

(3) A person who manufactures or, in the course of a business, imports into [F4Great Britain] a ceramic article must on request make available to an authorised officer appropriate documentation to demonstrate that the ceramic article complies with the migration limits for lead and cadmium set out in regulation 10 including—

(a)the results of the analysis carried out;

(b)the test conditions;

(c)the name and the address of the laboratory that performed the testing.

(4) Paragraphs (1), (2) and (3) do not apply in relation to a ceramic article which is second-hand.

(5) The documentation specified in paragraph (3)(a), (b) and (c) is not required where documentary evidence is provided to show that the materials used to make the ceramic article did not contain lead or cadmium.

(6) In regulation 18, after paragraph (2) insert—

(3) The method of analysis used for checking compliance with paragraph (1) must comply with the criteria set out in paragraphs (4), (5) and (6).

(4) The level of vinyl chloride in materials and articles and the level of vinyl chloride released by materials and articles to foodstuffs are determined by means of gas-phase chromatography using the ‘headspace’ method.

(5) For the purposes of determining vinyl chloride released by materials and articles to foodstuffs, the detection limit is 0.01 milligrams of vinyl chloride per kilogram of food.

(6) Vinyl chloride released by materials and articles to foodstuffs is in principle determined in the foodstuffs. When the determination in certain foodstuffs is shown to be impossible for technical reasons, a food authority may permit determination by simulants for these particular foodstuffs.

[F5(6A) In regulation 27(1)(a)(i), for “10(4), 10(6)” substitute “10A(1), 10A(3).

(6B) In Schedule 2, in paragraph 1, in the substituted section 10(1A), for “10(4), 10(6)” substitute “10A(1), 10A(3).]

(7) After Schedule 2, insert the new Schedules 3 to 5 set out in the Schedule to these Regulations.

Back to top

Options/Help

Print Options

Close

Legislation is available in different versions:

Latest Available (revised):The latest available updated version of the legislation incorporating changes made by subsequent legislation and applied by our editorial team. Changes we have not yet applied to the text, can be found in the ‘Changes to Legislation’ area. The revised version is currently only available in English.

Original (As Enacted or Made) - English: The original English language version of the legislation as it stood when it was enacted or made. No changes have been applied to the text.

Original (As Enacted or Made) - Welsh:The original Welsh language version of the legislation as it stood when it was enacted or made. No changes have been applied to the text.

Point in Time: This becomes available after navigating to view revised legislation as it stood at a certain point in time via Advanced Features > Show Timeline of Changes or via a point in time advanced search. A point in time version is only available in English.

Close

See additional information alongside the content

Geographical Extent: Indicates the geographical area that this provision applies to. For further information see ‘Frequently Asked Questions’.

Show Timeline of Changes: See how this legislation has or could change over time. Turning this feature on will show extra navigation options to go to these specific points in time. Return to the latest available version by using the controls above in the What Version box.

Close

Opening Options

Different options to open legislation in order to view more content on screen at once

Close

More Resources

Access essential accompanying documents and information for this legislation item from this tab. Dependent on the legislation item being viewed this may include:

  • the original print PDF of the as enacted version that was used for the print copy
  • lists of changes made by and/or affecting this legislation item
  • confers power and blanket amendment details
  • all formats of all associated documents
  • correction slips
  • links to related legislation and further information resources
Close

Timeline of Changes

This timeline shows the different points in time where a change occurred. The dates will coincide with the earliest date on which the change (e.g an insertion, a repeal or a substitution) that was applied came into force. The first date in the timeline will usually be the earliest date when the provision came into force. In some cases the first date is 01/02/1991 (or for Northern Ireland legislation 01/01/2006). This date is our basedate. No versions before this date are available. For further information see the Editorial Practice Guide and Glossary under Help.

Close

More Resources

Use this menu to access essential accompanying documents and information for this legislation item. Dependent on the legislation item being viewed this may include:

  • the original print PDF of the as made version that was used for the print copy
  • correction slips

Click 'View More' or select 'More Resources' tab for additional information including:

  • lists of changes made by and/or affecting this legislation item
  • confers power and blanket amendment details
  • all formats of all associated documents
  • links to related legislation and further information resources